How To Set Up A Remote Control

FOR YOUR SURROUNDBAR IHT

SMARTBAR™ PROGRAMMING NOTE:

For your SurroundBar to respond to your remote control, you MUST FIRST program the bar to respond to your television’s original IR (Infra-Red) remote. An RF (Radio Frequency) remote will not work. Other remotes (cable, satellite) will work only after you have programmed the bar to respond to the TV’s IR remote.

Programming Instructions: Your SurroundBar IHT is currently programmed to respond to the remote control that is included with the product. However, we strongly recommend program- ming the SurroundBar to also respond to your existing remote control using the steps illustrated below. This will enable you to operate all of your components using a single remote control. While programming the SurroundBar, ignore anything that may be displayed on the TV screen.

Example: To teach your bar the “Volume Up” command of your remote control:

1The SurroundBar is turned on and the LED is solid green. And you have sound coming from the bar.

2Press and hold “LEARN” for 2 seconds, or until LED blinks orange, then release the “LEARN” button.

LEARN SOURCE

LED

Blinks orange

3Press and release Volume Up “ .” LED turns solid orange.

MUTE

LED

Solid orange

4Hold TV remote 1' - 2' from SurroundBar.

1' - 2'

5Tap “Volume Up” button on your TV’s remote control 4 - 8 times, once per second. Tap, do not hold.

LED

LED blinks with

VOL

each button press

6When the LED blinks green quickly for 3 seconds, the command has been learned. The LED will become solid green.

LED

LED blinks green,

VOL

then turns solid green

Verify command works.

Repeat steps 1-6 to program “Volume Down” (), Source, Mute and Power buttons ( ).

Note: If your bar fails to learn certain IR remote codes, the power LED will blink red. Try erasing any previously programmed codes (see below) and carefully repeat steps 1-6 above.

Code Erasing Procedure: If you have programmed your SurroundBar IHT to respond to a remote control and you no longer want it to do so, erase the codes by pressing the LEARN key for about two seconds while the unit is in standby mode (power LED

is red). You’ll know that previously learned codes have been successfully erased when the power LED blinks orange twice.

Note: This procedure removes ALL of your bar’s remote control programming. If you only need to change the programming for some of the bar buttons, follow the six steps in the sequence previously described to redo any previous programming.

The SurroundBar will continue to respond to the provided credit card remote control.