OPTION #2 Receivers with full-range (unfiltered) left and right “PRE OUT” jacks (this is the least commonly used hookup).

SUB-OUT RECEIVER

OUTPUT

CENTER

FRONT

REAR

DC 5V 1A

TROUBLESHOOTING

Subwoofer does

Ensure the subwoofer is plugged

not power on.

 

into a live wall outlet.

 

Ensure the rear panel power switch

 

 

is in the “On” or “Auto” position.

No sound from

Turn up the volume control.

subwoofer.

Ensure the channel ID switches on the

 

 

transmitter and Wireless Subwoofer

 

 

are set to the same number.

Bass output not loud enough.

Turn up the Wireless Subwoofer’s

 

 

volume control.

 

Place the Wireless Subwoofer closer

 

 

to a corner of the room.

The Subwoofer’s sound

Turn off both the the transmitter and the

is intermittent, sounds

 

Wireless Subwoofer. Then turn them back

weak or is distorted.

 

on to re-establish communication.

 

Try changing settings of the Channel ID

 

 

switches on both the transmitter and the

 

 

Wireless Subwoofer.

The two switches must be set to the same position for the subwoofer to receive a signal.

WIRELESS TRANSMITTER

WIRELESS SUBWOOFER

– The Wireless Subwoofer could be too far

away from the transmitter to receive a

sufficiently strong signal. Try moving it closer.

A Note Regarding Wireless Performance:

Connect the left and right front preamp outputs to the left and right inputs of the transmitter.

Adjust the settings on your receiver as follows: Front Speakers = LARGE

Subwoofer = OFF or NO

ADJUSTING YOUR SUBWOOFER

Note: When you set up your subwoofer for the first time, you will probably have to make adjustments several times before you hear what you personally like.

FINE TUNING YOUR SUBWOOFER

Volume: Adjust by ear using a wide variety of CDs and video sources. Adjust for deep, powerful bass without “boominess.”

Low Pass Filter Control: NOTE: This control does not operate when the subwoofer is connected with Option #1 (LFE Input). This control, which is located on the back of the amplifier, adjusts the frequency range over which the subwoofer operates. When using smaller main speakers the upper range of the control will probably yield the best results. With larger speakers the lower end of the control range will probably sound best, but always let your ear be the final judge. If male vocals sound “thin,” turn this control up until the voice sounds rich but not “boomy.”

If male vocals sound too “thick” or chesty,” turn this control down until the voice sounds natural.

Phase Switch: Playing music and sitting in your listening position, carefully listen for the point at which the subwoofer transitions to your main speakers. This is the crossover point, and this point should be below the frequency of a male human voice. Whichever phase setting sounds louder or fuller at the subwoofer’s crossover point

is the optimum setting. Sometimes no difference will be heard.

Like all wireless devices, your PSWi225 may be susceptible to RF interference from such sources as microwave ovens, WiFi computer systems, video game systems, cordless telephones, blue tooth systems, baby monitors and other devices. In particular, any devices operating in the 2.4GHz band may cause intermittent wireless connections between the PSWi225. It is also possible that your PSWi225 may affect other wireless systems. For the most part, you can avoid wire- less performance problems by physically separating these devices from your PSWi225. Maintaining a distance of several feet or more between your PSWi225 speaker and any wireless device should prevent any mutual interference effects. If you do notice any subwoofer signal dropouts take care to identify the root cause (most commonly having other wireless devices too close) and resolve accordingly. Any interference effects from a microwave oven will cease once the oven stops operating and may be resolved on a long-term basis by increasing the physical distance between your PSWi225 and the microwave oven.

TECHNICAL ASSISTANCE AND SERVICE

If, after following these hookup directions, you experience difficulty, please double-check all wire connections. Should you isolate the problem to the subwoofer, contact the authorized Polk Audio dealer where you made your purchase, or call Polk Audio’s friendly Customer Service Department at

1-800-377-7655 (calls from US or CAN only), 410-358-3600 9am to 6pm EST, Monday through Friday.

You may also contact us via email: polkcs@polkaudio.com. For more detailed

hookup information and manual updates, visit: www.polkaudio.com.

Specifications can be found on the PSWi225 web pages. Go to www.polkaudio.com.

Customer Service Hours of Operation: Monday-Friday, 9AM-6PM EST

polkcs@polkaudio.com

5

Page 5
Image 5
Polk Audio PSWi225 Troubleshooting, Adjusting Your Subwoofer, Technical Assistance and Service, Fine Tuning Your Subwoofer

PSWi225 specifications

The Polk Audio PSWi225 is a notable addition to the world of wireless subwoofers, designed to deliver rich, deep bass while seamlessly integrating with your audio setup. One of its standout features is the 10-inch driver, which provides powerful low-frequency response, enhancing the overall sound quality during music playback, movies, or gaming.

One of the key technologies integrated into the PSWi225 is the use of Polk’s proprietary power port technology. This innovation allows for larger, air-filled ports to minimize distortion and improve bass performance. The Power Port design ensures that the subwoofer delivers a full-bodied sound, enabling a punchier bass response that can truly elevate the listening experience.

Moreover, the PSWi225 offers a wireless connection, allowing for easy placement anywhere in the room without the hassle of cables. This feature is particularly appealing to those who appreciate a clean, uncluttered aesthetic. The wireless capabilities are made possible through a built-in amplifier that provides 200 watts of dynamic power, ensuring that the subwoofer can handle even the most demanding soundtracks without breaking a sweat.

The PSWi225 is not only designed for performance but also for ease of use. It features simple volume and crossover controls on the rear panel, allowing users to tailor the subwoofer to their particular space and preferences. Its frequency response ranges from 38Hz to 160Hz, granting excellent flexibility in adjusting bass levels to suit various media, whether it be traditional stereo music or multi-channel home theater sound.

Additionally, the PSWi225’s design is both stylish and functional. The low-profile cabinet with a sleek finish makes it an attractive addition to any room, complementing other audio equipment and home decor. Its built-in feet and non-slip design help maintain stability, even during intense listening sessions.

In summary, the Polk Audio PSWi225 subwoofer combines advanced technology with aesthetic appeal, providing users with enhanced audio experiences. By incorporating features such as wireless connectivity, power port technology, and user-friendly controls, the PSWi225 stands out as a powerful yet versatile subwoofer that meets the demands of modern entertainment setups.