Polycom® RSS™ 4000 Getting Started Guide – Version 6.0
Parameter
Description
| the DHCP server could change over time. | |
|
| |
Using the following IP | Select this option to use the static IP address. You may need to | |
manually enter the IP address, subnet mask, and gateway IP | ||
Address | ||
address. | ||
| ||
|
| |
| Used in combination with the DHCP option. When the Obtain an IP | |
Obtain DNS Server | Address Automatically (DHCP) option is selected, the system will | |
Address Automatically | automatically obtain DNS server address from a DHCP server in the | |
| network. | |
|
| |
Using the following | If you did not select the option to automatically obtain DNS address, | |
you must enter the preferred/alternate DNS server addresses here | ||
DNS Server Address | ||
for the system to resolve domain names. | ||
| ||
|
| |
| The Network Address Translation (NAT) function of the system | |
Using the following | enables you to translate the private network IP address of packet into | |
a public network IP address before transmission. To enable NAT, | ||
NAT Server | ||
select this check box and then enter the public network IP address to | ||
| ||
| be displayed publicly. | |
|
| |
| Sets the speed/duplex modes for LAN ports. Supports the 10/100M | |
| Full Duplex or Half Duplex mode and the 1000M network. Select | |
LAN Speed | Auto to use | |
Note: When setting LAN port speed, contact your network | ||
| ||
| administrator to ensure that the switch link rate matches the system | |
| port. | |
|
|
9Click Update and a dialog box will pop up, in which you should confirm to restart the system to apply the setting.
To change IP address via RS-232 Console or Telnet:
1Connect your PC to the RS232 port of the Polycom® RSS™ 4000 with a serial port cable and activate the console port (115200，8bits).
2After you logged in to the console port, input the default password POLYCOM to enter the system.
3Enter "?" or "help" after the prompt "#" and the system displays available command information.
4Change IP address using the command in the format below:
set lan1 ip {dhcp static <ip> netmask <mask> gw <gateway>}
5
