Replacing a RTM Isdn Card | Polycom DOC2547A manual

Chapter 1- Hardware Description

The blue HS LEDs on the MPM/MPM+ card and the Control Unit start flashing and the power on cycle for the card is initiated:

—The card’s resources are added to the system resources list

—The number of available ports on the RMX is increased to the current CFS license level

—Port usage is re-calculated and the Port Gauges and Video/Voice Port Configuration are updated

When the power on cycle of the MPM/MPM+ card is completed, the blue HS LEDs will turn OFF. The green RDY LED on the MPM/ MPM+ card switches on and remains lit.

Replacing a RTM ISDN Card

The RTM ISDN card can only be used with software version 3.0 or higher.

1Ensure that the power switch on the RMX 2000 is turned OFF (O).

2Loosen the captive screws that fasten the card to the MCU.

3Remove the RTM ISDN card. Use the metal ejector levers to pull the RTM ISDN card out of its slot in the backplane.

4Carefully slide the RTM ISDN card out through the front panel.

5On the card to be installed, move the ejector levers to their fully open position.



		Ejector Lever
			Captive Screw

1-34

Image 40

Polycom DOC2547A manual Replacing a RTM Isdn Card

Contents

Polycom RMX 2000 System Hardware Guide USA Regulatory Notices United States Federal Communication Commission FCC Chinese Communication Certificate Singapore Certificate Table of Contents Table of Contents Main Features Hardware Description RMX 2000 Specifications System Capacities Following table summarizes the different system capacities Video Resolution Resources with MPM+ Rack Mount Safety Precautions Safety RequirementsSite Requirements Installation Precautions RMX 2000 Components RMX 2000 Front Panel Component Description Cntl CPU Component Description RMX 2000 Rear Panel RTM IP Following items appear on the RMX 2000 rear panel Management Network on page G-1 RTM Isdn All external connectors are located on the rear panel Cables Connected to the RTM IP & Isdn Cards RMX 2000 LEDs RMX 2000 Front Panel LEDsFollowing items appear on the RMX 2000 front panel Component Card removal Initiated The card Card Insertion Initiated If during Cntl Unit Following LEDs appear on the RTM IP card RMX 2000 Rear Panel LEDsLED Color Description Name ShMG LEDs Following LEDs appear on the RTM Isdn Function Name MPM and MPM+ Configuration Modes Port Type Maximum Possible MPM+ Resource Capacities Card Resources Bandwidth TypeHD720p HD1080p @30fps @60fps MPM+ Up to MPM and MPM+ Modes Both MPM cards are enabled An RMX has two MPM cards installedRemove one MPM card Insert one MPM+ card Remove the MPM+ card Insert one MPM card RMX Chassis Types RMX 2000 General Information dialog box opens Component Replacement Fully Open The card is released from the MCU housing Types of Ejector Levers on RMX Components Replacing the Cntl Module Handle Polycom RMX 2000 Hardware Guide Replacing the Power Supply Module Replacing the Fan Drawer Replacing a Faulty MPM/MPM+ Card Removing the MPM/MPM+ Card from the MCU Installing a New MPM/MPM+ Card in a Powered On RMX Installing the Replacement MPM/MPM+ Card Replacing a RTM Isdn Card PRI Cables Replacing the RTM IP Card