Polycom RMX 2000 Hardware Guide
Replacing a Functional MPM Module
Use the following procedure to replace a faulty MPM Module types F or H:
1Ensure that power switch to the RMX is turned OFF (O).
2Unscrew the screws on the front panel of the RMX that secure the MPM Module.
3Use the metal ejectors to pull the MPM Module out of its slot in the Backplane.
4Carefully slide the MPM Module out through the front panel.
5Slide in the replacement MPM Module.
6Push the MPM Module firmly into the Backplane, making sure it is properly seated in its slot.
7Ensure that the metal ejectors are fully retracted into their housings.
8Tighten the screws on the front panel of the RMX that secure the MPM Module.
9Turn ON the RMX.
