Chapter 1- Hardware Description
Replacing the RTM IP Board
The RTM IP board on the rear of the RMX 2000 provides connectivity to all the MCU modules. Use the following procedure to replace the RTM IP board:
1Ensure that power switch to the RMX 2000 is turned OFF (O).
2Unscrew the screws on the rear panel of the RMX 2000 that secure the RTM IP board.
3Use the metal ejectors to pull the RTM IP board out of its slot in the Backplane.
4Carefully slide the RTM IP board out through the rear panel.
5Slide in the replacement RTM IP board.
6Push the RTM IP board firmly into the Backplane, making sure it is properly seated in its slots.
7Ensure that the metal ejectors are fully retracted into their housings.
8Tighten the screws on the rear panel of the RMX 2000 that secure the RTM IP board.
9Turn ON the RMX 2000.
