Polycom RMX 2000 Hardware Guide
Prior to removing an MPM board the captive screws must be unscrewed and the ejector levers must be used to “power down” the card. Powering down of the card by lightly pulling on the MPM card’s ejector mechanism. Once the ejector levers have been pulled a removal sequence is initiated and the process cannot be terminated. When present, the HS LED flash on the MPM and Control Unit. When the HS led is constantly lit the card is powered down, you can remove the card. Power up is achieved when the card is
Installing an new MPM card in a powered On RMX2000:
1If applicable, loosen the captive screws and remove the slot cover.
2On the card to be installed, move the ejector levers to their full open position.
3Insert the card into the slot until the ejector levers touch the front edge of the card cage.
4Push the ejector levers to their fully closed position and tighten the captive screws on each side of the card, securing the MPM RTM card to the RMX.
The blue HS LEDs on the MPM card and the Control Unit start flashing and the power on cycle for the card is initiated:
—The card’s resources are added to the system resources list
—The number of available ports on the RMX is increased to the current CFS license level
—Port usage is
When the power on cycle of the MPM card is completed, the blue HS LEDs will turn OFF. The green RDY LED on the MPM card switches on and remains lit.
