Porter-Cable 100H Operation, Attaching the Motor to the Router Base, Adjusting Depth of CUT

907395 - 12-20-02.qxd 12/20/02 9:13 AM Page 8

ATTACHING THE MOTOR TO THE ROUTER BASE

DISCONNECT TOOL FROM POWER SOURCE.

1.Open the clamp (A) Fig. 1 and set the power unit in the base unit.

2.Align the lower pin of the power unit (B) Fig. 1 with the groove in the base.

3.Rotate the power unit CLOCKWISE into the base until the upper guide pins are set in the groove of the base.

4.Close the clamp.

ADJUSTING DEPTH OF CUT

DISCONNECT TOOL FROM POWER SOURCE.

1.Open the clamp (A) Fig. 3A.

2.Hold the base (E) and turn the power unit (F) Fig. 3A COUNTER-CLOCK- WISE until the tip of the bit is above the bottom of the base.

3.Set the tool on a flat surface.

4.Turn the power unit (F) Fig. 3A CLOCKWISE until bit touches the work.

5.Close the clamp (A) Fig. 3A.

6.Rotate the depth adjusting ring (B) Fig. 3A until the zero-line (C) Fig. 3B is opposite the index line (D) Fig. 3B on the housing.

7.Open the clamp (A) Fig. 3A.

8.Tip the router so that the bit is clear of the wood surface. Turn the power unit (F) Fig. 3A CLOCKWISE until the index line (D) Fig. 3B on the motor housing reaches the desired depth indicated on the ring.

9. Close the clamp (A) Fig. 3A.

F

B

E

C

D

A

Fig. 3A Fig. 3B

NOTE: Setting the index line to 1/4" on the ring means the cutting edge of the bit is exposed 1/4" below the base.

OPERATION

CONNECTING TO POWER SOURCE

Before connecting tool to power source ALWAYS MAKE SURE SWITCH IS IN THE “OFF” POSITION. Also check that the power circuit is the same as that shown on specification plate of the router.

8