FLUSH TRIMMING
1.
DISCONNECT TOOL FROM POWER SOURCE.
2.Attach base and guide to trimmer as outlined under ASSEMBLING AND ADJUSTING BASE AND ROLLER.
3.Remove roller guide and replace with flush trimming guide (B) Fig. 2. This guide may be identified by the molded on letter “F”. The stud on the end of this guide must face toward the trimmer base.
4.Install guide setting gauge (E) Fig. 2, into trimmer collet (see TO INSTALL BIT). Install trimmer motor to base. Adjust guide so that hole in end of gauge may be positioned over the guide stud.
5.Remove guide setting gauge from trimmer and install flush trimming bit.
6.Adjust depth of cut so that the straight portion of the bit extends below the trimmer base at least the thickness of the material to be trimmed.
7.Make a trial cut on scrap material. Readjust if necessary.
BEVEL TRIMMING
1.Follow Steps 1 through 5 under FLUSH TRIMMING, except install bevel trimming guide (C) Fig. 2. This guide is identified by the letter “B” molded onto it.
2.Adjust depth of cut so that only the bevel portion of the bit extends below trimmer base at least the thickness of the material to be trimmed.
3.Make a trial cut on scrap material to check alignment. Readjust if necessary.
USING STRAIGHT EDGE GUIDE
The straight edge guide (D) Fig. 2, maybe used with either bit for trimming straight edges.
Assemble it to the guide base and adjust similar to the other guides.
TROUBLESHOOTING
For assistance with your tool, visit our website at
13
