Porter-Cable instruction manual Models 333 and 333VS, Dust Collector Models 333, 333VS

Fig. 2 Fig. 3

Models 333 and 333VS:

1. DISCONNECT TOOL FROM POWER SOURCE.

2.Place machine on workbench with pad up (see Fig. 3).

3.Clean dust from pad face.

4.Position Hook & Loop Abrasive Disc onto sander pad, aligning the dust extraction holes in paper with holes in pad. NOTE: When using 8-hole abrasive on model 333VS, align the hole pattern in the abrasive with the groove in the sander pad.

Do not use PSA (Pressure Sensitive Adhesive) disc with Hook & Loop pad as the disc may be thrown from the pad causing personal injury.

5.Press disc firmly onto pad.

Failure to properly seat disc to pad may result in disc being thrown from pad causing personal injury.

6.To remove disc, peel disc away from pad.

DUST COLLECTOR (Models 333, 333VS and 334)

1. DISCONNECT TOOL FROM POWER SOURCE.

2.Position dust collector to sander nozzle as shown in Fig. 4. Seat collector onto nozzle.

3.Periodically remove dust container from flange and empty collected dust, Fig. 5.

NOTE: A slight twisting action will ease removal and reassembly.

Tap container lightly to remove compacted dust. DO NOT WASH CONTAINER. Dry compressed air may be used to blow out container.

DUST

COLLECTOR

NOZZLE

Fig. 4

11