900276 -
OPERATION
HOW TO HOLD SHEAR
WARNlNG: The gear housing, intermediate plate, and cutting head may be made live if the tool cuts into live wiring. To prevent accidental shock, the tool must be held as shown in Fig. 1.
Fig. 1
TO START AND STOP SHEAR
CAUTION: Make sure switch is in OFF position and hands, body and clothing are clear of cutting head before connecting tool to power circuit.
1.Squeeze trigger switch (A) Fig. 2, to start motor. Release trigger switch to stop motor.
2.A lock button (B) Fig. 2, is provided to keep motor running without holding the trigger switch ON.
3.To lock the trigger switch ON, squeeze the trigger as far as it will go, push in lock button and release trigger. NOTE: When the trigger is locked, the tool will only run at the maximum speed.
B
A
Fig. 2
4.To unlock lock button, squeeze trigger and release, leaving lock button free to spring out.
5.As the trigger switch is squeezed, the cutting speed increases.
6
