C
Fig. 4
ASSEMBLING THE MOTOR IN THE ROUTER BASE EQUIPPED WITH TWO HANDLES
1.CAUTION: DISCONNECT MOTOR FROM POWER SOURCE.
2.Loosen the clamp screw (A) Fig. 1 to allow the power unit to be set in the base unit.
3.Insert motor unit into base aligning lower pin (B) with groove in base.
4.Rotate motor unit CLOCKWISE into base until upper guide pins are rigidly set in the groove of the base.
5.Tighten clamp screw firmly.
ASSEMBLING THE MOTOR IN THE ROUTER BASE EQUIPPED WITH SWITCH
1.CAUTION: DISCONNECT BOTH POWER CORDS (base and motor)
FROM POWER SOURCE.
2.Loosen clamp screw (A) Fig. 3 to allow the power unit to be set in the base unit.
3.With the motor switch (C) positioned as shown in Fig. 3, insert the motor unit into the base aligning lower pin (B) with groove in base.
4.Rotate the motor unit CLOCKWISE into the base two revolutions.
5.Connect the motor unit cord to the outlet in handle as shown in Fig. 4.
6.Tighten clamp screw firmly.
ADJUSTING DEPTH OF CUT
1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.Loosen clamp screw (A) Fig. 5.
3.While holding base (E), turn motor unit (F) Fig. 5 COUNTERCLOCKWISE until the tip of the bit is above bottom surface of base.
4.Set router on flat wood surface.
7
