Porter-Cable 7556 instruction manual Carton Contents, Assembly, Installing and Removing Drill BIT

	CARTON CONTENTS
* Right angle drill	* Open end wrench
* Side handle	* Pin wrench
* Chuck key

ASSEMBLY

INSTALLING AND REMOVING DRILL BIT

1.DISCONNECT TOOL FROM POWER SOURCE.

2.The three-jaw chuck is designed for self-centering of the drill bit. Open chuck jaws by turning outer sleeve counterclockwise, when viewing the chuck from the bit end. Open large enough so that bit shank can be inserted.

3.Clean and insert smooth end of drill bit as far as it will go into the chuck, then withdraw bit approximately 1/16", or up to the flutes for small bits.

4.While holding the bit with one hand, turn outer sleeve clockwise until bit is gripped in the chuck.

5.Tighten chuck – insert chuck key into each of 3 keyholes in chuck body (Fig. 1) in succession and tighten securely by turning key clockwise.

6.Be sure chuck key is removed before starting tool.

7.To remove bit, reverse this procedure.

LOOSEN TIGHTEN

Fig. 1

TO INSTALL AUXILIARY HANDLE

An auxiliary handle (C) Fig. 2, is supplied and can be installed on either side of the tool. This handle screws directly into the drill housing providing complete control of the drill.

It is strongly recommended that the auxiliary handle be used and tool held as illustrated in Fig. 3A during all drilling operations.

E GA

C

FB

Model 7556

Fig. 2

9