903549 -
TO INSTALL AUXILIARY HANDLE
An auxiliary handle (C) Fig. 2, is supplied with some models. This handle screws directly into the drill housing providing complete control of the drill.
It is strongly recommended that the auxiliary handle be used and tool held as illustrated in Fig. 4 during all drilling operations.
OPERATION
TO START AND STOP THE MACHINE
1.CAUTION: Make sure switch is OFF and power circuit voltage is the same as that shown on the specification plate.
2.Connect tool to power circuit.
3.Grip machine firmly to resist starting torque.
4.To START the machine in FORWARD (clockwise rotation), depress the bottom of the trigger switch (A) Fig. 3.
To START the machine in REVERSE (counterclockwise rotation), depress the top of the trigger switch (B) Fig. 3.
NOTE: Allow motor to stop before attempting to reverse direction of rotation. Failure to do so, could damage motor.
5.TO STOP the machine, release the trigger switch.
B
A
Fig. 3
HOW TO HOLD THE DRILL
WARNING: The front end of drill may be made live if the tool drills into live wiring in a wall. TO PREVENT ACCIDENTAL ELECTRICAL SHOCK, DRILL MUST BE HELD AS SHOWN IN FIG. 4.
An auxiliary handle (C) Fig. 2, is supplied with each drill. The auxiliary handle should be used during all drilling operations: firmly grasp auxiliary handle with one hand and switch handle with the other hand as shown in Fig. 4.
Fig. 4
7
