Porter-Cable 7765 instruction manual Maintenance, Keep Tool Clean, Failure to Start

➞

➞

F

Fig. 7

G

H

J

Fig. 8

MAINTENANCE

KEEP TOOL CLEAN

Periodically blow out all air passages with compressed air. ALL PLASTIC PARTS SHOULD BE CLEANED WITH SOFT CLOTHS. CAUTION: Never use any solvents to clean plastic parts. Plastics can be easily damaged by such solvents.

CAUTION: Wear safety glasses when using compressed air.

FAILURE TO START

Should your tool fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.

BRUSH INSPECTION AND LUBRICATION

For your continued safety and electrical protection, brush inspection and replacement on this tool should ONLY be performed by an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-CABLE/DELTA SERVICE CENTER.

At approximately 100 hours of use, take or send your tool to your nearest Authorized Porter-Cable Service Station to be thoroughly cleaned and inspected; worn parts replaced, when necessary; relubricated with fresh lubricant, if required; reassembled with new brushes; and performance tested.

Any loss of power before the above maintenance check may indicate the need for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION. If proper operating voltage is present, return your tool to the Service Station for immediate service.

8