902387 -
B
A
Fig. 2
B
C
Fig. 3
3.Release adjusting collar being sure that the depressions in the collar engage the projections on the clutch housing.
4.Drive a test fastener in a piece of scrap material identical to that to be used. Examine results of drive and make additional depth stop adjustment if required as follows:
a)To increase depth of drive, repeat STEP 1 and turn adjusting collar so that end of nutsetter extends beyond end of depth stop.
b)To decrease depth of drive, repeat STEP 1 and turn adjusting collar so that end of depth stop extends beyond end of nutsetter.
Each 1/8 turn of the adjusting collar results in .010" change in depth of drive.
5.Repeat STEPS 3 and 4 until desired result is obtained.
C
ABD
Fig. 4
7
