Porter-Cable BN200A, 894884-003 instruction manual Troubleshooting, Service And Repairs

SERVICE AND REPAIRS

All quality tools eventually require servicing or replacement of parts due to wear from normal use. Some user serviceable components are described in the TROUBLESHOOTING Section. Complete product Service is available from either an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-CABLE SERVICE CENTER. All repairs made by these agencies are fully guaranteed against defective material and workmanship. We cannot guarantee repairs made or attempted by anyone other than these agencies.

Should you have any questions about your tool, feel free to write us at any time. In any communications, please give all information shown on the nameplate of your tool (model number, type, serial number, etc.).

TROUBLESHOOTING

CAUTION: Disconnect tool from air supply before performing any Service Procedure.

SYMPTOM PROBLEMS SOLUTIONS

1.Air leak near top of tool or in trigger area.

Loose screws.	Tighten screws.
Worn or damaged	Install “OVERHAUL” Maintenance Kit.
o-rings or seals.

2.Tool does nothing or operates sluggishly.

Inadequate air supply.	Verify adequate air supply.
Inadequate lubrication.	Put 5 or 6 drops of oil into air inlet.
Worn or damaged	Install “DRIVER” Maintenance Kit.
o-rings or seals.

3.Air leak near bottom of tool.

Loose screws.	Tighten screws.
Worn or damaged	Install “OVERHAUL” Maintenance Kit.
o-rings or bumper.

4.	Tool jams frequently. Incorrect fasteners.	Verify approved fasteners of
		correct size.
	Damaged fasteners.	Replace w/undamaged fasteners.
	Magazine or nose	Tighten screws.
	screws loose.
	Magazine is dirty.	Clean magazine.
	Driver is worn or damaged.	Install “DRIVER” Maintenance Kit.
5.	Other.	Contact a Porter-Cable
		Service Facility.

9