| SPECIFICATIONS |
Free Speed | 600 RPM |
Maximum Working Pressure | 90 PSI |
Air Inlet | 1/4" NPT |
Recommended Hose Size | 3/8" I.D. |
Keyless Chuck | 1/2” |
Air Consumption @ 90 PSI | 6.0 SCFM |
|
|
| ASSEMBLY |
|
|
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.
Assemble Stabilizer Handle
1.Slide stabilizer handle onto tool, rotate to desired position and tighten.
OPERATION
Chuck
|
| Reverse | |
|
| and | |
Stabilizer | Trigger | Forward | |
Lever | |||
Handle |
| ||
|
|
Air Inlet
Before each use:
●Drain water from air compressor tank and condensation from air lines. See air compressor’s operators manual.
Disconnect the tool from the air supply before lubricating or changing drill bits.
●
●
●
●
Lubricate tool, see “Maintenance” section in this manual. Open the keyless chuck (A), no tools are required.
Insert and center drill bit in the jaws (B) as you close chuck. NOTE: An off centered drill bit will wobble and could break. Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is recommended.
B
A
5- ENG | D22722 |