6.If the handle has excessive movement, it is improperly installed. Check the following.
A.Are both tabs inside the handle (Step #3)?
B.Does each clip pass through both the saddle and handle (Step #4)?
To Assemble Wheels
It will be necessary to brace or support one side of the unit when installing
the wheels because the compressor will have a tendency to tip.
1.Attach wheels with shoulder bolts and nuts as shown.
Wheel
Nut
Shoulder Bolt
2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.
The wheels and handle do not
provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1.Attach rubber feet with the screws, washers, and nuts provided as shown.
2.Tighten securely.
Nut
Flat
Washer
Rubber Foot
Screw
D24938 | 10- ENG |
