Never point tool at yourself or others.
Always connect tool to air supply before loading fasteners (Fig. 18).
Do not load fasteners with trigger or safety depressed.
Only use approved
Operator and others in work area MUST wear safety glasses with side shields. Always wear ANSI Z87.1 approved safety glasses, and ANSI S3.19 approved hearing protection when preparing or operating the tool.
Never use a tool that is leaking air, has missing or damaged parts, or requires repair.
2.Pull follower (A) Fig. 19, all the way to the rear, until it latches.
3.Insert a strip of approved fasteners, see Fig. 20. Orient fasteners with points down. Slide fasteners forward to the front of the magazine. The magazine will hold two full strips of fasteners.
4.Depress follower release lever (A) Fig. 21, allowing the follower to slide forward against the fasteners.
Fig. 18
Fig. 19
A
Fig. 20
Fig. 21
A
5.Adjust directional exhaust deflector
(A) Fig. 22, so that the exhaust air blast will be directed away from the operator. The exhaust deflector provides seven detented positions for directing the exhaust blast away from the operator. Grasp the deflector and rotate it to the desired position for the current application.
A | Fig. 22 |
8
