PUMP
This screen filter should be checked periodically and cleaned if necessary.
1.Remove filter by grasping end and removing it from water inlet of pump as shown.
2.Clean filter by flushing it with water on both sides.
3.Install filter into water inlet of pump
2.Disconnect spark plug wire.
3.Pull trigger on gun handle to relieve any water pressure.
4.Disconnect the wand from the gun.
5.Remove the
Filter Screen
6. Direct water supply into nozzle end to backflush loosened parti- cles for 30 seconds.
WAND
If the nozzle becomes clogged with foreign materials, such as dirt, exces- sive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pul- sate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions:
1.Shut off the pressure washer and turn off the water supply.
7.Reassemble the nozzle to the wand.
8.Reconnect wand to gun and turn on water supply.
9.Start pressure washer and place wand into high pressure setting to test.
D25115 | 16- ENG |
