4.Attach high pressure hose to gun. Tighten securely.
5.Connect wand to gun. Tighten securely.
6.Place the nozzle holder onto the panel (located on the handle assembly) and push each nozzle holder into place.
7.Remove five colored quick connect nozzles from plastic bag and insert them into correct grommet on the nozzle holder. NOTE: Nozzles are color coded to match colored nozzles on panel.
8.Slide the formed rubber covers onto the handle's
9.Add engine oil (supplied) to engine. Refer to Engine Owners Manual supplied by engine manufacturer for correct procedure.
NOTE: There will be a slight amount of oil in the engine from factory testing.
NOTE: The high pressure pump was filled with oil at the factory. There is no need to add oil at this time, see the Maintenance section of this manual for Maintenance information.
The shipping plug must be removed and replaced with the dipstick/oil
plug before operating pressure washer.
10.Using a 7/8" wrench, remove shipping plug from pump by turning it counterclockwise. Discard plug.
11.Remove dipstick/oil plug from plastic bag and install into pump, tighten securely.
A08058 | 8- ENG |
