CF MEMORY CARD READER
If the CF card reader is installed and the CF card is used for system data storage device, it is recognized by the system as the IDE channel 1 Master device. The CF memory card reader inside main unit accepts a type II CF memory card. Please note that usual utilities such as FDISK.EXE or
FORMAT.COM must never be used on CF card or permanent damage can occur. If this option is installed, the standard SATA HDD in main unit is not applicable.
HDD & SATA PORT
The 2.5” HDD in the main unit is connected to the system through internal Serial ATA (SATA) connector. The optional HDD in the base unit if installed is connected to the system through SATA port. The internal SATA HDD will be detected as “Ch. 0 M.” and the HDD connected to the SATA port will be detected as “Ch. 0 S.” in “Advanced BIOS Features” Æ “Hard Disk Boot Priority” of BIOS setup. Both IDE or SATA controller can be set to “Disabled” in “Integrated Peripherals” Æ “OnChip IDE Device” of BIOS setup when required. Both are set to IDE mode for data transfer.
TOUCH PANEL
All paragraphs below are applicable for models with touch panel only. The user of those models without touch panel can ignore them and consider this user’s manual ends here.
Mouse Emulation
The touch panel in KS system uses USB interface. When the touch driver is properly installed, this touch panel works exactly like a standard mouse of USB interface. However, if the system is running under safe mode, most drivers are disabled in this mode and the touch panel calibration is therefore not guaranteed. It is recommended to use a standard USB mouse or keyboard in this mode.
All the below mentioned mouse emulation functions can be manipulated through relevant software. The system can give a beep and a click on the left button of a mouse at the point when the touch panel is touched. If the point touched is dragged across the screen surface, it works as the mouse drag and drop feature. If the point is touched, released and touched within a short time interval, it is
Part 14
