POSIFLEX Business Machines LM-6601 user manual Hardware Installation, VGA Port Power Preparation

V.HARDWARE INSTALLATION

A.VGA Port Power Preparation

1.Inquire for technical support from your dealer to set the power support in the VGA port of the FT system following the relevant Technical Manual of the FT system. Please note that once the VGA port is no longer to be occupied by the LM-6601, this power support must be discontinued!

B.Fix Bracket onto LM-6601

2.Unfold down the semi-circular base tongue of the

LM-6601 main unit and apply the L shape bracket on this base tongue. Use the 2 screws in the accessory bag to fix the bracket over the base tongue as circled in the right picture. Note that the slots for the screws on the bracket allow some adjustment on position of LM-6601 for application.

C.Open Back Cover & Pole Cover of FT System

3.Refer to the User’s Manual of the FT system about “INSTALLING BASE MOUNT KIT” to open back cover and remove the 2 arrowed

screws to remove the pole cover. Preserve the 2 screws for the next step.

D.Install LM-6601 to FT System

4.Install the slender part of the L shape bracket to the hole for pole cover

and screw it to top cover of FT base tightly at the arrowed holes as in the left picture and result is shown at the right.

E.Cable Connection

5.Connect the VGA cable that has both 3 x 5 D sub male ends to VGA port at rear of LM-6601 and the VGA port of host system. Screw in the cable to connectors at both ends.

F.Driver Installation

6.There is no need to install driver for use of LM-6601. However, the supported display modes are tabulated at last part of this manual

Part 3