Switch Position | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | |
Serial interface | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF | |
w/ auto cutter | |||||||||
|
|
|
|
|
|
|
| ||
Parallel interface | ON | ON | OFF | OFF | OFF | OFF | OFF | OFF | |
w/ auto cutter | |||||||||
|
|
|
|
|
|
|
|
C.INTERNAL SWITCH
There is an extra internal 4 position DIP switch in
This 4 position DIP switch works as following:
ê | Switch position | Setting Effect | |
Function | ON | OFF | |
1 | Factory internal setting | Disable | Default |
2 | Paper width | 58 mm | 80 mm |
3 | Line format | 576 dots / line | 512 dots / line |
4 | Reserved | N. A. | N. A. |
The Switch position 1 default set to ON. The print speed is fixed at 42.5 lines/sec.
Switch position 2 is usually set to OFF for use with 80 mm paper width. When the printer is installed with the 58 mm paper guide adaptor for use with the paper roll of 58 mm width, the switch should be set to ON in
Switch position 3 is usually set to OFF for ESC/POS command application that prints at 512 dots / line. Only technical users shall set this switch to ON and make the printer work in the 576 dots / line format.
D.SOFTWARE COMMANDS
The Aura thermal printer supports all commands applicable to Epson printer
Part 4