Poulan 115267626 Fuel System, Other, Load Adjustment Engine, Empty fuel tank and refill with

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message labeled IMPORTANT regarding the use of gasohol in your chain saw. Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Follow the mix instructions found on stabilizer containers. Run engine at least 5 minutes after adding stabilizer. Poulan/WEED EATER 40:1, 2-cycle engine oil (air cooled) is blended with fuel stabilizer. If you do not use this oil, you can add a fuel stabilizer to your fuel tank.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distrib- ute oil.

SReplace spark plug with new one of rec- ommended type and heat range.

SClean air filter.

SCheck entire unit for loose screws, nuts, and bolts. Replace any damaged, broken,

or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

S Replace your gasoline can if it starts to rust.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

TROUBLE	CAUSE		REMEDY
Engine will not	1. Ignition switch off.		1.	Move ignition switch to ON.
start or will run	2. Engine flooded.		2.	See “Difficult Starting” in
only a few				Operation Section.
seconds after	3. Fuel tank empty.		3.	Fill tank with correct fuel mixture.
starting.	4. Spark plug not firing.		4.	Install new spark plug.
	5. Fuel not reaching		5.	Check for dirty fuel filter; replace.
		carburetor.		Check for kinked or split fuel line;
				repair or replace.
Engine will	1.	Idle speed requires	1. See “Carburetor Adjustment” in the
not idle		adjustment.		Service and Adjustments Section.
properly.	2.	Carburetor requires	2. Contact an authorized service dealer.
		adjustment.
Engine will not	1.	Air filter dirty.	1. Clean or replace air filter.
accelerate,	2.	Spark plug fouled.	2. Clean or replace plug and regap.
lacks power,	3.	Chain brake engaged.	3. Disengage chain brake.
or dies under	4.	Carburetor requires	4. Contact an authorized service dealer.
a load.		adjustment.
Engine	1.	Too much oil mixed with	1.	Empty fuel tank and refill with
smokes		gasoline.		correct fuel mixture.
excessively.
Chain moves	1. Idle speed requires		1. See “Carburetor Adjustment” in the
at idle speed.		adjustment.		Service and Adjustments Section.
	2. Clutch requires repair.		2.	Contact an authorized service dealer.

18