OPERATION

season. See Storage Instructions for additional information.

When mowing large areas, start by turning to the right so

Never use engine or carburetor cleaner products in the fuel

 

that clippings will discharge away from shrubs, fences,

tank or permanent damage may occur.

 

driveways, etc. After one or two rounds, mow in the

 

 

 

opposite direction making left hand turns until finished

CAUTION: Fill to bottom of gas tank

 

 

 

 

(See Fig. 8).

filler neck. Do not overfill. Wipe off any

 

 

 

If grass is extremely tall, it should be mowed twice to

spilled oil or fuel. Do not store, spill or

 

 

 

reduce load and possible fire hazard from dried clip-

use gasoline near an open flame.

 

 

 

 

pings. Make first cut relatively high; the second to the

 

 

 

TO START ENGINE (See Fig. 6)

desired height.

When starting the engine for the first time or if the engine has

Do not mow grass when it is wet. Wet grass will plug

 

mower and leave undesirable clumps. Allow grass to dry

run out of fuel, it will take extra cranking time to move fuel

 

 

before mowing.

from the tank to the engine.

 

Always operate engine at full throttle when mowing

• Sit on seat in operating position, depress clutch/brake

 

to assure better mowing performance and proper dis-

pedal and set parking brake.

 

 

charge of material. Regulate ground speed by selecting

• Place gear shift lever in neutral (N) position.

 

 

a low enough gear to give the mower cutting perfor-

• Move attachment clutch to “DISENGAGED” position.

 

 

mance as well as the quality of cut desired.

• Move throttle control to fast position

 

When operating attachments, select a ground speed

• Pull choke control out for a cold engine start attempt. For

 

that will suit the terrain and give best performance of the

a warm engine start attempt the choke control may not

 

 

attachment being used.

be needed.

 

 

 

NOTE: Before starting, read the warm and cold starting

 

 

procedures below.

 

 

• Insert key into ignition and turn key clockwise to

 

 

“START” position and release key as soon as engine

 

 

starts. Do not run starter continuously for more than

 

 

fifteen seconds per minute. If the engine does not start

 

 

after several attempts, push choke control in, wait a few

 

 

minutes and try again. If engine still does not start, pull

 

 

 

FIG. 8

the choke control out and retry.

 

 

 

WARM WEATHER STARTING (50° F and above)

MULCHING MOWING TIPS

• When engine starts, slowly push choke control in until

IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER

the engine begins to run smoothly. If the engine starts

HOUSING FREE OF BUILT-UP GRASS AND TRASH.

to run roughly, pull the choke control out slightly for a few

CLEAN AFTER EACH USE.

seconds and then continue to push the control in slowly.

The special mulching blade will recut the grass clippings

• The attachments and ground drive can now be used. If

 

many times and reduce them in size so that as they fall

the engine does not accept the load, restart the engine

 

onto the lawn they will disperse into the grass and not be

and allow it to warm up for one minute using the choke

 

noticed. Also, the mulched grass will biodegrade

as described above.

 

quickly to provide nutrients for the lawn. Always mulch

COLD WEATHER STARTING (50°F and below)

 

with your highest engine (blade) speed as this will

• When engine starts, slowly push choke control in until

 

provide the best recutting action of the blades.

the engine begins to run smoothly. Continue to push the

Avoid cutting your lawn when it is wet. Wet grass tends

choke control in small steps allowing the engine to

 

to form clumps and interferes with the mulching action.

accept small changes in speed and load, until the choke

 

The best time to mow your lawn is the early afternoon.

control is fully in. If the engine starts to run roughly, pull

 

At this time the grass has dried and the newly cut area

the choke control out slightly for a few seconds and then

will not be exposed to the direct sun.

continue to push the control in slowly. This may require

For best results, adjust the mower cutting height so that

an engine warm-up period from several seconds to

 

the mower cuts off only the top one-third of the grass

several minutes, depending on the temperature.

 

blades (See Fig. 9). For extremely heavy mulching,

• The attachments can be used during the engine warm-

 

reduce your width of cut on each pass and mow slowly.

up period and may require the choke control be pulled out

Certain types of grass and grass conditions may require

slightly.

 

that an area be mulched a second time to completely

NOTE: If at a high altitude (above 3000 feet) or in cold

 

hide the clippings. When doing a second cut, mow

temperatures (below 32 F) the carburetor fuel mixture may

 

across or perpendicular to the first cut path.

need to be adjusted for best engine performance. See “TO

Change your cutting pattern from week to week. Mow

ADJUST CARBURETOR” in the Service and Adjustments

 

north to south one week then change to east to west the

section of this manual.

 

next week. This will help prevent matting and graining

MOWING TIPS

 

of the lawn.

 

 

Mower should be properly leveled for best mowing

performance. See “TO LEVEL MOWER HOUSING” in

MAX 1/3

the Service and Adjustments section of this manual.

 

The left hand side of mower should be used for trimming.

Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the

machine. This will result in a more even distribution of

 

 

13

FIG. 9

clippings and more uniform cutting.

 

Page 13
Image 13
Poulan 175682 owner manual To Start Engine See Fig, Mulching Mowing Tips

175682 specifications

The Poulan 175682 is a robust and versatile chainsaw designed for both residential and light commercial use. Known for its reliability and performance, it is a favorite among homeowners, landscapers, and those tackling outdoor projects. This chainsaw strikes a perfect balance between power and maneuverability, making it an excellent choice for cutting firewood, trimming trees, and clearing brush.

One of the main features of the Poulan 175682 is its powerful engine. Equipped with a 42cc two-stroke engine, it delivers consistent power to handle various cutting tasks efficiently. This engine is designed for optimal performance, ensuring that the saw runs smoothly even in demanding conditions. Additionally, the engine incorporates advanced technology that reduces fuel consumption and emissions, making it an environmentally friendly choice for users concerned about their ecological footprint.

The chainsaw's cutting capability is enhanced by a durable 18-inch bar and chain. The length provides enough reach to tackle larger logs while remaining manageable for precise cutting. The chain is designed for sharpness and longevity, enabling users to make clean cuts with minimal effort. Furthermore, the automatic oiler system ensures that the chain remains lubricated during operation, reducing wear and tear while prolonging the chainsaw's lifespan.

Another standout feature of the Poulan 175682 is its user-friendly design. The weight is well-balanced, allowing for easy handling and control during use. It comes equipped with an anti-vibration system, which minimizes vibrations felt by the operator, reducing fatigue during extended periods of cutting. Safety features, such as the chain brake and throttle lockout, add an extra layer of protection for users, making it a trustworthy option even for those new to chainsaw operation.

In terms of maintenance, the Poulan 175682 is designed with convenience in mind. The easily accessible air filter and spark plug make routine upkeep straightforward, enabling users to keep their chainsaw in top condition. With its combination of power, ease of use, and safety features, the Poulan 175682 is an excellent investment for anyone looking to tackle a variety of cutting tasks efficiently and safely. Whether for firewood preparation or yard maintenance, this chainsaw delivers the performance needed to get the job done effectively.