11. Assemble new belt, idler pulleys and bottom belt keeper to idler bracket. Tighten pulley bolts securely.
NOTE: Be sure belt is inside top belt keeper on idler assembly.
12.Position belt and idler assembly in trimmer, reconnect idler spring and as- semble idler to chassis.
Engine pulley
Chassis
Spacer
Control cable
Belt
Idler assembly
Top belt keeper
Bolt
13.Install belt around trimmer head pulley and engine pulley.
14.Replace debris shield and tighten the four (4) screws securely.
15.Replace chassis cover and tighten screw securely.
Idler bracket | Flat idler |
Nut Spacer
Idler spring
Bottom belt keeper
Flat idler
Trimmer head pulley
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your unit to a qualifi ed service center for repair and/or adjustment.
CARBURETOR
Your carburetor has a nonadjustable
fixed main jet for mixture control. If your engine does not operate properly due to suspected carburetor problems, take your
unit to a qualifi ed service center for repair and/or adjustment.
IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the
STORAGE
Immediately prepare your trimmer for stor- age at the end of the season or if the unit will not be used for 30 days or more.
TRIMMER
When trimmer is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.
1.Clean entire trimmer (See "CLEAN- ING" in the Maintenance section of this manual).
2.Lubricate as shown in the Maintenance section of this manual.
3.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect
moving parts for damage, breakage
15and wear. Replace if necessary.
