Poulan 193747 manual USE Hardware Group E, Assemble Engine Zone Control Cable to Engine

ASSEMBLE REMOTE THROTTLE CONTROL TO ENGINE (ON MODELS SO EQUIPPED)

(USE HARDWARE GROUP “E”)

NOTE: If your lawn mower does not have a remote throttle control, go on to

“ASSEMBLE ENGINE ZONE CONTROL CABLE TO ENGINE”.

•First, move lever on remote throttle control to the CHOKE (if equipped) or FAST/START position.

FAST / START

CHOKE

Determine the manufacturer and brand or type engine on your lawn mower and fol- low the appropriate instructions that follow.

MODELS WITH BRIGGS & STRATTON CLASSIC OR SPRINT AND MODELS WITH TECUMSEH ENGINES:

NOTE: Tecumseh engines have cable mounting clamp and screw preassembled on engine.

•At engine carburetor, insert wire “Z” bend of throttle control into hole of speed lever (use inner hole on Briggs & Stratton engine).

•(Briggs & Stratton only) Assemble di- ecast clamp and #10 x 5/8 screw loosely to engine.

•Position throttle cable under clamp and push cable towards speed lever until speed lever touches boss. Hold cable at this po- sition and tighten clamp screw securely.

Speed lever

Diecast clamp

#10 x 5/8

Hex head screw

(BRIGGS & STRATTON ENGINE SHOWN) (Clamp and Screw are preassembled on Tecumseh engines)

BRIGGS & STRATTON CLASSIC AND SPRINT ENGINES:

•Attach throttle cable to side of engine housing with cable clip and #10 x 5/8 hex washer head screw. Tighten securely.

Throttle cable

#10 x 5/8

Hex head screw

Cable clip

MODELS WITH BRIGGS & STRATTON QUANTUM ENGINES:

•Slide throttle lever on engine to CHOKE position (away from spark plug). Push gently beyond first stop to lock in detent (CHOKE position).

•Insert wire “Z” bend of throttle cable into throttle lever hole from top side.

•Secure throttle cable to engine with diecast clamp and #10 x 5/8 hex head screw and tighten securely.

Hex		Throttle cable Throttle
Head		lever
Screw
#10 x	5/8

Diecast clamp

12