Poulan 177110 Steering To Adjust Mower Cutting Height, To Operate on Hills, To Operate Mower

TRACTOR -- MODEL NUMBER 271470

STEERING

38

63

11

39

1

41

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move

lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

• The average lawn should be cut to

approximately 2-1/2 inches during the

cool season and to over 3 inches

during hot months. For healthier and

better looking lawns, mow often and

after moderate growth.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•	Choose the slowest speed before
	starting up or down hills.
•	Avoid stopping or changing speed on
	hills.
• If slowing is necessary, move throttle
	control lever to slower position.
•	If stopping is absolutely necessary,
	push clutch/brake pedal quickly to
	brake position and engage parking
	brake.
•	Move gearshift lever to 1st gear. Be
	sure you have allowed room for tractor
	to roll slightly as you restart movement.
•	To restart movement, slowly release
	parking brake and clutch/brake pedal.

42

37

37

36

6244

51

54

8 27 17

18

19

23 22

11

66

40

29

79

80

	25
	68
29	82

15

15	29
	15

	68	67	67
46
8	47		67
6	13
9	65
2	85	46
		8
7	85	6
9		9
5			47
		7
3	32	9
		5
	11
	26		4
			43
	40
			43
	28		6
			8
	10
	30

• For best cutting performance, grass

over 6 inches in height should be

mowed twice. Make the first cut

relatively high; the second to desired

height.

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

•Select desired height of cut.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disen- gage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

Attachment Clutch Lever

“Engaged” Position

Attachemnt

Lift Lever

High Position

Low

Position

“Disengaged” Position

Deflector

Shield

• Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

36 13