Manuals / Poulan / Lawn and Garden / Snow Blower

Poulan 96198001900 Before Starting the Engine, Scraper BAR, Check Engine OIL Level See Fig

Models: 96198001900 415324

1 32
Download 32 pages 16.8 Kb
Page 11
Image 11

OPERATION

•If snow thrower must be operated over gravel surface, use extra caution and be sure skid plates are adjusted to lowest (highest scraper clearance) position.

1.Shut off engine and wait for all moving parts to stop.

2.Adjust skid plates by loosening the hex nut, then mov- ing skid plate to desired position. Be sure both plates are adjusted evenly. Tighten securely.

HIGH POSITION

(LOW GROUND

CLEARANCE)

AUGER HOUSING SCRAPER BAR

SKID PLATE HEX NUT

LOW POSITION (HIGH GROUND CLEARANCE)

FIG. 15

CHOKE CONTROL

SAFETY

IGNITION

KEY

RECOIL

STARTER

HANDLE

THROTTLE PRIMER ENGINE OIL FILL CAP / DIPSTICK

GASOLINE

FILLER CAP

FUEL SHUT-

OFF VALVE

STARTER BUTTON

POWER CORD PLUG

SCRAPER BAR

The scraper bar is not adjustable, but is reversible. After considerable use it may become worn. When it has worn almost to the edge of the housing, it can be reversed, providing additional service before requiring replacement. Replace a damaged or worn scraper bar.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 17)

The engine on your snow thrower has been shipped, from the factory, already filled with oil.

1.Check engine oil with snow thrower on level ground.

2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•To change engine oil, see “TO CHANGE ENGINE OIL”

in the Maintenance section of this manual.

ADD GASOLINE (See Fig. 17)

•Fill fuel tank to bottom of tank filler neck. Do not over- fill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

WARNING: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can at- tract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

NOTE: ALL ITEMS ARE SHOWN IN THEIR TYPICAL LOCATION. ACTUAL LOCATION MAY VARY WITH ENGINE ON YOUR UNIT.

TO START ENGINE

FIG. 22

 

Your snow thrower engine is equipped with both a 120 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A.C. household current.

•Be sure your house is a 120 Volt A.C. three-wire grounded system. If you are uncertain, consult a licensed electrician.

WARNING: Do not use the electric starter if your house is not a 120 Volt A.C. three-wire grounded system. Se- rious personal injury or damage to your snow thrower could result.

COLD START - ELECTRIC STARTER

1.Insert safety ignition key (packed separately in parts bag) into ignition slot until it clicks. DO NOT turn the key. Keep the extra safety ignition key in a safe place.

2.Place ON / OFF switch in “ON” position.

3.Rotate choke control to “FULL” position.

4.Connect the power cord to the engine.

5.Plug the other end of the power cord into a three-hole

grounded 120 Volt A.C. receptacle.

NOTE: Do not use primer when starting engine with the electric starter.

6. Push starter button until engine starts.

IMPORTANT: Do not crank engine more than five con- tinuous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt.

7.When the engine starts, release the starter button and slowly move the choke control to the “OFF” position.

8.Disconnect the power cord from the receptacle first, then from the engine.

Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operat-

11 ing temperature.

Page 10 Page 12
Page 11
Image 11
Poulan 96198001900, 415324 Before Starting the Engine, Scraper BAR, Check Engine OIL Level See Fig, ADD Gasoline See Fig
Page 10 Page 12

96198001900, 415324 specifications

The Poulan 415324,96198001900 is a powerful and reliable string trimmer designed for both homeowners and professionals alike. Its robust construction and advanced technology make it an ideal choice for tackling a wide array of landscaping tasks.

One of the standout features of the Poulan 415324 is its high-performance engine. This trimmer is equipped with a 25cc two-cycle engine that provides ample power for cutting through thick grass and weeds. The engine ensures easy starting and efficient fuel consumption, which translates into longer run times and less frequent refueling. Coupled with a lightweight design, users can maneuver the trimmer with ease, reducing fatigue during extended use.

The Poulan 415324 boasts an impressive cutting width of 17 inches. This allows users to trim large areas quickly and efficiently, making it perfect for large lawns or gardens. The dual line feed system automatically advances the trimmer line when needed, ensuring a consistent cutting performance. This feature eliminates downtime spent adjusting the line and allows users to focus on the job at hand.

Another essential characteristic of this string trimmer is its adjustable handle. The ergonomic design allows for personalized height adjustments, providing comfort while reducing strain on the arms and back. This feature is especially beneficial for users of varying heights, ensuring everyone can find a comfortable grip.

Safety is an essential aspect of the Poulan 415324's design. It comes equipped with a safety guard that protects the user from debris while trimming. This guard is not only practical but enhances the overall user experience by minimizing potential accidents.

Additionally, the Poulan 415324 incorporates advanced technologies such as easy-start technology, which reduces the amount of effort needed to start the engine. This feature is particularly useful for those who may struggle with traditional pull-start mechanisms, making it accessible for a wider range of users.

In conclusion, the Poulan 415324,96198001900 string trimmer is a versatile and efficient tool that meets the demands of both casual and serious gardening enthusiasts. With its powerful engine, wide cutting capacity, adjustable ergonomic handle, and safety features, it stands out in the market. Whether maintaining a home garden or tending to professional landscaping needs, the Poulan 415324 is a reliable choice that delivers excellent performance and ease of use.