SERVICE AND ADJUSTMENTS

TO REMOVE WHEELS (See Fig. 21)

•Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the axle hole closest to the end of the shaft – do not use the hole in the wheel hub (if equipped). Inner hole in axle and hole in wheel hub are not used for your model snow thrower.

KLIK PIN (INSTALL

OUTER HOLE

IN OUTER HOLE

 

OF AXLE ONLY)

 

AXLE

WHEEL

WHEEL HUB

FIG. 21

NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

ENGINE

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 2,134 meters. If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a Sears service centre/department.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a Sears service centre/de- partment, which has the proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS” in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Alcohol blended fuels (called gasohol or using ethanol or metha- nol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

•Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour approximately one ounce (30 ml) of oil through spark plug hole into cylinder.

3.Pull recoil starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Remove safety ignition key; store in a safe place.

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your snow thrower indoors and cover it to protect it from dust and dirt.

•Cover your snow thrower with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your snow thrower to rust.

IMPORTANT: Never cover snow thrower while engine/

17 exhaust area is still warm.

Page 16 Page 18
Page 17
Image 17
Poulan 96198001900, 415324 owner manual Storage, Other
Page 16 Page 18

96198001900, 415324 specifications

The Poulan 415324,96198001900 is a powerful and reliable string trimmer designed for both homeowners and professionals alike. Its robust construction and advanced technology make it an ideal choice for tackling a wide array of landscaping tasks.

One of the standout features of the Poulan 415324 is its high-performance engine. This trimmer is equipped with a 25cc two-cycle engine that provides ample power for cutting through thick grass and weeds. The engine ensures easy starting and efficient fuel consumption, which translates into longer run times and less frequent refueling. Coupled with a lightweight design, users can maneuver the trimmer with ease, reducing fatigue during extended use.

The Poulan 415324 boasts an impressive cutting width of 17 inches. This allows users to trim large areas quickly and efficiently, making it perfect for large lawns or gardens. The dual line feed system automatically advances the trimmer line when needed, ensuring a consistent cutting performance. This feature eliminates downtime spent adjusting the line and allows users to focus on the job at hand.

Another essential characteristic of this string trimmer is its adjustable handle. The ergonomic design allows for personalized height adjustments, providing comfort while reducing strain on the arms and back. This feature is especially beneficial for users of varying heights, ensuring everyone can find a comfortable grip.

Safety is an essential aspect of the Poulan 415324's design. It comes equipped with a safety guard that protects the user from debris while trimming. This guard is not only practical but enhances the overall user experience by minimizing potential accidents.

Additionally, the Poulan 415324 incorporates advanced technologies such as easy-start technology, which reduces the amount of effort needed to start the engine. This feature is particularly useful for those who may struggle with traditional pull-start mechanisms, making it accessible for a wider range of users.

In conclusion, the Poulan 415324,96198001900 string trimmer is a versatile and efficient tool that meets the demands of both casual and serious gardening enthusiasts. With its powerful engine, wide cutting capacity, adjustable ergonomic handle, and safety features, it stands out in the market. Whether maintaining a home garden or tending to professional landscaping needs, the Poulan 415324 is a reliable choice that delivers excellent performance and ease of use.
Top Page Image Contents