![](/images/new-backgrounds/1175923/1759239x1.webp)
ASSEMBLY / PRE-OPERATION
NOTE: The
UNFOLD UPPER HANDLE
1.Raise upper handle to the operating position and tighten handle knobs securely. Additional carriage bolts, washers and handle knobs are in bag of parts. Use to secure upper handle to lower handle. Install in lower holes in handles.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1. Remove plastic tie securing rod to lower handle.
SPEED |
CONTROL |
ROD |
PLASTIC TIE |
UPPER |
HANDLE |
HANDLE |
KNOB |
LOWER |
HANDLE |
FIG. 1
SPEED CONTROL ROD | |
| RETAINER |
| SPRING |
SPEED | SPEED |
CONTROL | CONTROL |
BRACKET | LEVER |
FIG. 2
2.Insert rod into speed control bracket and secure with retainer spring.install traction DRIVE control rod (See Figs. 3 and 4)
The traction drive control rod has the long loop on the end of the spring as shown.
1.Slide rubber sleeve up rod and hook end of spring into pivot bracket with loop opening down as shown.
2.With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in drive control bracket. Secure with retainer spring.
TRACTION DRIVE |
CONTROL ROD |
RUBBER |
SLEEVE |
LOOP OPEN- |
ING DOWN |
PIVOT |
BRACKET |
FIG. 3
TRACTION DRIVE | RETAINER |
CONTROL LEVER | SPRING |
| TRACTION |
| DRIVE |
| CONTROL |
| ROD |
DRIVE |
|
CONTROL |
|
BRACKET |
|
FIG. 4
5