Poulan 421916 owner manual Operation, Meets A.N.S.I. Safety Requirements

OPERATION

GASOLINE

FILLER CAP

MUFFLER

CHOKE CON-

TROL

PRIMER

SAFETY

IGNITION

KEYON / OFF SWITCH

NOTE: ITEMS ABOVE

ARE SHOWN IN

THEIR TYPICAL

LOCATION ON THE

ENGINE. ACTUAL

LOCATION MAY VARY

WITH THE ENGINE

ON YOUR UNIT.

AUGERS

ELECTRIC	AUGER		DISCHARGE CHUTE CONTROL LEVER
START BUTTON	CONTROL
	LEVER	DRIVE SPEED		DEFLECTOR	TRACTION
RECOIL				REMOTE	DRIVE
		CONTROL LEVER
(AUXILIARY)				CONTROL	CONTROL
STARTER				LEVER	LEVER
HANDLE
	CHUTE
DEFLECTOR
					LH TURN
					TRIGGER
DISCHARGE
CHUTE
					LIGHT
CLEAN-OUT TOOL					HANDLE
					KNOB
					MUFFLER
					TOOLBOX

SKID PLATE

FIG. 10

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox - used to store spare shear bolts, locknuts and wrench.

Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button - used for starting the engine.

Recoil (auxiliary) starter handle - used for starting engine.

Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.

Choke Control - used for starting a cold engine.

Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.

LH and RH turn triggers - used to steer the snow thrower. 9

Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw snow).

Discharge chute control lever - used to change the di- rection the snow is thrown.

Deflector remote control lever - used to change the distance the snow is thrown.

Skid plate - used to adjust height of scraper bar from the ground.