OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE 
CON-
TROL
PRIMER
SAFETY
IGNITION
KEYON / OFF SWITCH
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC AUGER
START BUTTON CONTROL RECOIL LEVER
(AUXILIARY) STARTER HANDLE
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
TOOL
FIG. 10
DRIVE
SPEED CONTROL LEVER
DISCHARGE CHUTE
CONTROL LEVER
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN
TRIGGER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
LH and RH turn triggers - used to steer the snow thrower. Choke control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Deflector remote control lever - used to change the distance the snow is thrown.
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
9
