Poulan 96192003500, 428861, XT11530ES Parts Packed Separately in Carton, Assembly / PRE-OPERATION

PARTS PACKED SEPARATELY IN CARTON

(1) FUEL STABILIZER PACKET	(1) MULTI-
	WRENCH
	(180684)

(1) POWER CORD	SAFTEY IGNITION KEY(S)
(198563)	(193071)

(1) AUGER CONTROL ROD

(1) DISCHARGE CHUTE

EXTRA SHEAR BOLTS AND NUTS

(2) SHOULDER	(2) LOCKNUTS
BOLT 1/4-20 x 1-3/4	1/4-20
(192090)	(73800400)

ROTATOR HEAD MOUNTING

(3) RETAINER SPRINGS (169675)

(1) WASHER 3/8	(1) LOCKNUT 3/8
(19131316)	(73800600)

CHUTE DEFLECTOR REMOTE CONTROL

(1) LOCKNUT	(1) CARRIAGE BOLT	(1) LOCKNUT	(1) SHOULDER	(1) SPRING
5/16-18	5/16-18 x 5/8	1/4-20	BOLT 1/4-20
(751153)	(72250505)	(191730)	(179829)	(184505)

(2)FLAT WASHERS

(2)CARRIAGE BOLTS 3/8-16 x 2.25

(2)HANDLE KNOBS

ASSEMBLY / PRE-OPERATION

Read these instructions and this manual in its entirety		2.	Cut down all four corners of carton and lay panels flat.
before you attempt to assemble or operate your new		3.	Remove the two (2) screws securing the auger housing
snow thrower. Reading the entire manual will familiar-
			to the pallet.
ize you with the unit, which will assist you in assembly,
		4.	Remove all packing materials except plastic tie holding
operation and maintenance of the product.
			speed control rod to lower handle.
Your new snow thrower has been assembled at the factory
		5. Remove the two (2) plastic ties securing the upper
with the exception of those parts left unassembled for ship-
			handle to the pallet.
ping purposes. All parts such as nuts, washers, bolts, etc.,
		6. Remove snow thrower from carton and check carton
necessary to complete the assembly have been placed in
the parts bag. To ensure safe and proper operation of your			thoroughly for additional loose parts.
snow thrower, all parts and hardware you assemble must		HOW TO SET UP YOUR SNOW THROWER
be tightened securely. Use the correct tools as necessary
to ensure proper tightness.		TOOL BOX (See Fig. 10)
REMOVE SNOW THROWER FROM CARTON		A toolbox is provided on your snow thrower. The toolbox is
1. Remove all accessible loose parts and parts boxes		located on top of the belt cover. Store the extra shear bolts,
	4	nuts and multi-wrench provided in parts bag in the toolbox.
from carton.