Exploded | Poulan 437921, 96198003602 specification

REPAIR PARTS SNOW THROWER - MODEL NUMBER PP291E27 (96198003602)

DRIVE

								42 EXPLODED
									46
	2
									45
					16		17
				1			17
				1
								18	47
									47
					15 14	15			49
			12	911		15			49
	11		12	911		20		22	24
	9			53					24
9	9			53				19
9	10			13				19		23
				13	53				4
		11			53			34	4
8	53
7	53					21
6						21
6									24
	5								24
	5								33
									33
	53					23
	53
	3					31		33
						31		33
					29	30		32
					29			32
			26	28				38
			26				35	53
24		27					35	53
24
	26					36

4			37		42
					42	44
						44
23	25	53	39			43
24	25
					41
				40		01.02.013-A
		39				01.02.013-A
		39

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 32

Image 32

Poulan 437921, 96198003602 owner manual Exploded

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerParts Packed Separately in Carton Remove Snow Thrower from Carton Unfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotator Head See Fig Install Chute Deflector Remote Control See Figs Check Tire Pressure Operation Know Your Snow ThrowerPrimer Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engine HOW to USE Your Snow Thrower StoppingTo USE Fuel SHUT-OFF Valve See Fig To USE Choke Control See Fig To Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig To Adjust Skid Plates See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See Fig Snow Throwing Tips To Start EngineBefore Stopping If Recoil Starter has Frozen Maintenance General RecommendationsBefore Each USE Lubrication Cleaning Engine Service and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Adjust Cable Tension See Fig To Remove Wheels See FigCarburetor Engine Speed Storage OtherFuel System Engine OIL Troubleshooting Auger Housing KEY Part DescriptionScraper BAR Auger 27 LH Exploded Gearbox Assembly 178675X431 Corner Bracket Clean OUT ToolBearing Impeller Pulley Auger Bearing Bearing PlugSkid Plate LH Skid Plate RH Knob Black POP RivetChute Snow Shield Shield Retainer Strap LEVER/CABLE Rotator Assembly Cable Assembly AdjustableCable Assembly Heat Shield Rotator Head 427513X431 Pivot Support Weldment Loop Handle LHLoop Handle RH Spacer RetainerKnob RED Handle Knob Impeller ROD Traction ROD Wire Harness Console PanelHeadlight Bezel Flood Headlight 01.03.005-B Exploded Speed Selector Assembly Drive Plate AssemblyWheel HUB END Plate Complete LCT Engine Frame427963X428 Engine Mounting Plate Impeller Belt Traction BeltIdler ARM Bracket Idler Pulley 432336X421 Wheel Assembly LH432335X421 Safety Ignition KEY 422663 181037 DECAL, Danger Service Notes Limited Warranty

REPAIR PARTS SNOW THROWER - MODEL NUMBER PP291E27 (96198003602)

42 EXPLODED