WARNING: Remove fuel cap slow- ly when refueling.

FUELING ENGINE

This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand synthetic oil is recommended. A 40:1 ratio is obtained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline. Included with this saw is a 3.2 ounce container of Poulan/Weed Eater brand synthetic oil. Pour the entire contents of this container into 1 gallon of gasoline to achieve the proper fuel mixture.

DO NOT USE automotive or boat oil. These oils will cause engine damage. When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules listed under HANDLE FUEL WITH CAUTION.

BAR AND CHAIN LUBRICATION

The bar and chain require continuous lubri- cation. Lubrication is provided by the auto- matic oiler system when the oil tank is kept filled. Lack of oil will quickly ruin the bar and chain. Too little oil will cause overheating shown by smoke coming from the chain and/ or discoloration of the bar.

In freezing weather oil will thicken, making it necessary to thin bar and chain oil with a small amount (5 to 10%) of #1 Diesel Fuel or kerosene. Bar and chain oil must be free flowing for the oil system to pump enough oil for adequate lubrication.

Genuine Poulan or Poulan PROR bar and chain oil is recommended to protect your unit against excessive wear from heat and friction. Poulan or Poulan PROR oil resists high temperature thinning. If Poulan or Poulan PROR bar and chain oil is not available, use a good grade SAE 30 oil.

SNever use waste oil for bar and chain lubri- cation.

S Always stop the engine before removing the oil cap.

IMPORTANT

Experience indicates that alcohol--blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See STORAGE section for addi- tional information.

9

WARNING: The chain must not move when the engine runs at idle speed. If the chain moves at idle speed refer to CAR- BURETOR ADJUSTMENT within this manual. Avoid contact with the muffler. A hot muffler can cause serious burns.

To stop the engine move the ON/STOP switch to the STOP position.

To start the engine hold the saw firmly on the ground as illustrated. Make sure the chain is free to turn without contacting any object.

Use only 15”---18” of rope per pull. Hold saw firmly while pulling starter rope

Starter rope handle

Left hand

on front handle

Right foot through rear handle

IMPORTANT POINTS TO REMEMBER

When pulling the starter rope, do not use the full extent of the rope as this can cause the rope to break. Do not let starter rope snap back. Hold the handle and let the rope rewind slowly.

For cold weather starting, start the unit at FULL CHOKE; allow the engine to warm up before squeezing the throttle trigger.

NOTE: Do not cut material with the choke/ fast idle lever at the FULL CHOKE posi- tion.

STARTING A COLD ENGINE (or warm engine after running out of fuel):

NOTE: In the following steps, when the choke/fast idle lever is pulled out to the full extent, the correct throttle setting for starting is set automatically.

SMove ON/STOP switch to the ON position. S Pull out choke/fast idle to the full extent. S Slowly press primer bulb 6 times.

S Pull the starter rope quickly with your right hand 5 times. Then, Then, proceed to the next step.

NOTE: If the engine sounds as if it is try- ing to start before the 5th pull, stop pulling and immediately proceed to the next step.

SPush the choke/fast idle lever in complete-

ly (to the OFF position).

SPull the starter rope quickly with your right hand until the engine starts.

SAllow the engine to run for approximately 5 seconds. Then, squeeze and release throttle trigger to allow engine to return to idle speed.

Page 8 Page 10
Page 9
Image 9
Poulan 2001-08 Fueling Engine, BAR and Chain Lubrication, Important Points to Remember, Right foot through rear handle
Page 8 Page 10

530086596, 2001-08 specifications

The Poulan 2001-08,530086596 is a robust and versatile addition to the line of outdoor power equipment. Known for its reliability and performance, this tool is particularly favored by both homeowners and landscaping professionals.

One of its standout features includes a powerful engine designed for efficient operation in various tasks. The engine typically provides ample horsepower, making it suitable for cutting through thick underbrush and handling a range of yard maintenance jobs. The reliable ignition system further enhances starting efficiency, allowing users to get to work without the frustration of engine troubles.

The Poulan 2001-08,530086596 also comes with an ergonomic design that emphasizes user comfort. Its lightweight build allows for ease of movement, reducing fatigue during extended use. The handle is designed for a secure grip, which is particularly important for maintaining control while operating the equipment. The overall construction emphasizes both durability and functionality, ensuring that the tool can withstand the rigors of outdoor use.

In terms of technology, this model incorporates advanced features that enhance its usability. The inclusion of automatic oiling systems is a notable advantage, providing consistent lubrication to the cutting mechanisms. This feature minimizes maintenance efforts, allowing users to focus on the task at hand rather than worrying about upkeep.

The cutting capabilities of the Poulan 2001-08,530086596 are particularly impressive. It typically features adjustable cutting heights, allowing users to customize the length of grass or brush they are dealing with. This flexibility is essential for achieving professional-quality results in yard care projects.

Safety has not been overlooked in the design of the Poulan 2001-08,530086596. It is equipped with safety mechanisms that prevent accidental starts and ensure secure operation. Such features are critical in maintaining safe working conditions, especially in environments where users may encounter hazardous debris.

In summary, the Poulan 2001-08,530086596 stands out for its powerful engine, ergonomic design, advanced technology, versatile cutting capabilities, and safety features. Whether you are a homeowner looking to maintain your garden or a professional landscaper handling large projects, this equipment provides the performance and reliability necessary to tackle the challenges of outdoor maintenance effectively.
Top Page Image Contents