may void your warranty and cause damage to your unit.
DEmpty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and
letting it run until it stops.
D Do not use any accessory or attachment other than those recommended by manufac- turer for use with your unit.
DDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc.
DStore in a dry area out of reach of children.
SPECIAL NOTICE: Your blower is equipped with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion engines be equipped with a spark arrestor screen. If you operate a blower in a state or locale where
such regulations exist, you are legally re- sponsible for maintaining the operating condi- tion of these parts. Failure to do so is a viola- tion of the law.
SPECIAL NOTICE: Exposure to vibra- tions through prolonged use of gasoline pow- ered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel dam- age in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condi- tion of this tool.
WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in
CARTON CONTENTS
1.Engine Assembly
2.Hose Clamp with Screw
3.Flexible Tube
4.Base Tube
5.Middle Tube
6.Nozzle
7.Assembly Tool
Hose Clamps
the manual and on the unit.
DLocate and identify all components.
DSlip one hose clamp onto each end of the flexible tube.
DInstall the flexible tube onto the output tube
Output Tube
Base Tube
on the engine.
DConnect the base tube to the flexible tube and securely tighten both hose clamp screws.
DAssemble the middle tube and nozzle, then connect them to the base tube.
Flexible Tube
Middle Tube | Nozzle |
