7.Adjust the strap, allowing the hook to be about 3
8.Fasten the strap hook to the upper clamp and lift the tool to the operating position.
Shoulder Strap
Shoulder
Strap
Clamp
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the as- sist handle, be sure it remains directly above the coupler on the engine end shaft to ensure proper balancing of unit.
Assist Handle
Coupler
OPERATION
KNOW YOUR PRUNER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR PRUNER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Hanger
PrunerCoupler
Shaft |
| Bar oil fill cap |
| Chain | |
|
| |
| Bar | Bar nut |
|
|
PRUNER
The PRUNER is designed for removal of limbs and branches overhead not greater than 4 inches in diameter.
CHAIN TENSION
It is normal for a new chain to stretch during first 15 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION in the SERVICE AND AD- JUSTMENTS section.
OPERATING THE COUPLER
Your powerhead is equipped with a coupler which enables optional attachments to be installed. The optional attachments are:
MODEL: Edger . . . . . . . . . . . . . . . . . . . . . . . PP1000E Cultivator . . . . . . . . . . . . . . . . . . . . PP2000T Blower . . . . . . . . . . . . . . . . . . . . . . PP3000B Brushcutter . . . . . . . . . . . . . . . . . . PP4000C
WARNING: Always disconnect pow- erhead spark plug (or disconnect powerhead from power source) before removing or instal- ling attachments.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPTIONAL ATTACH- MENTS)
CAUTION: When removing or installing at- tachments, place the powerhead and attach-
ment on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
7