Starting a Warm Engine

IGNITION

SWITCH

STOP

Choke

Lever

1.Move ON/STOP switch to the ON posi- tion.

2.Pull choke/fast idle lever out to the full extent (to the FULL CHOKE position).

3.Slowly press primer bulb 6 times.

4.Pull the starter rope sharply 5 times with your right hand. Then, proceed to the next step.

NOTE: If the engine sounds as if it is trying to start before the 5th pull, stop pulling and immediately proceed to the next step.

5.Push the choke/fast idle lever in to the HALF CHOKE position.

CHOKE/FAST IDLE LEVER

OFF

HALF

FULL

6.Pull the starter rope sharply with your right hand until the engine starts.

7.Allow the engine to run for approximate- ly 5 seconds. Then, squeeze and re- lease the throttle trigger to allow engine to return to idle speed.

1.Move ON/STOP switch to the ON posi- tion.

2.Pull the choke/fast idle lever out to the FULL CHOKE position to set the fast idle, then push the lever in to the HALF CHOKE position.

3.Slowly press primer bulb 6 times.

4.Pull the starter rope sharply with your right hand until the engine starts.

5.Squeeze and release throttle trigger to allow engine to return to idle speed.

DIFFICULT STARTING (or starting a flooded engine)

The engine may be flooded with too much fuel if it has not started after 10 pulls. Flooded engines can be cleared of excess fuel by pushing the choke/fast idle lever in completely (to the OFF CHOKE position) and then following the warm engine starting procedure listed above. Ensure the ON/ STOP switch is in the ON position.

Starting could require pulling the starter rope handle many times depending on how badly the unit is flooded. If engine fails to start, refer to the TROUBLESHOOTING TABLE or call 1-800-554-6723.

CHAIN BRAKE

WARNING: If the brake band is worn too thin it may break when the chain brake is triggered. With a broken brake band, the chain brake will not stop the chain. The chain brake should be replaced by an autho- rized service dealer if any part is worn to less than 0.020″ (0.5 mm) thick. Repairs on a chain brake should be made by an autho- rized service dealer. Take your unit to the place of purchase if purchased from a ser- vicing dealer, or to the nearest authorized master service dealer.

SThis saw is equipped with a chain brake. The brake is designed to stop the chain if kickback occurs.

S The inertia--activated chain brake is activated if the front hand guard is pushed forward, either manually (by hand) or automatically (by sudden movement).

S If the brake is already activated, it is disengaged by pulling the front hand guard back toward the front handle as far as possible.

SWhen cutting with the saw, the chain brake must be disengaged.

Disengaged

Engaged

Braking function control CAUTION: The chain brake must be

checked several times daily. The engine must be running when performing this proce- dure. This is the only instance when the saw should be placed on the ground with the en- gine running.

Place the saw on firm ground. Grip the rear handle with your right hand and the front han- dle with your left hand. Apply full throttle by fully depressing the throttle trigger. Activate the chain brake by turning your left wrist against the hand guard without releasing your grip around the front handle. The chain should stop immediately.

Inertia activating function control

WARNING: When performing the following procedure, the engine must be turned off.

Grip the rear handle with your right hand and the front handle with your left hand. Hold the chain saw approximately 14″ (35 cm) above a stump or other wooden surface. Release your grip on the front handle and use the weight of the saw to let the tip of the guide bar fall forward and contact the stump. When the tip of the bar hits the stump, the brake should activate.

530165555 specifications

The Poulan 530165555 is a high-performance chainsaw engineered to tackle a wide range of cutting tasks, from trimming branches to felling large trees. Known for its reliability and ease of use, this model has gained popularity among both DIY enthusiasts and professionals alike.

One of the standout features of the Poulan 530165555 is its powerful engine. It is equipped with a robust two-cycle engine that delivers excellent power output, allowing users to efficiently cut through thick wood with ease. The engine is designed to provide maximum torque, which means that users can expect consistent performance even under demanding conditions.

Durability is another key characteristic of the Poulan 530165555. The chainsaw is constructed with high-quality materials that can withstand the rigors of regular use. Its heavy-duty frame and components ensure longevity and reliability, making it a worthy investment for anyone looking to maintain their property or work in forestry.

The Poulan 530165555 also boasts user-friendly features that enhance the overall experience. The chainsaw is designed with an ergonomic handle that provides a comfortable grip, reducing fatigue during prolonged operation. Additionally, the lightweight design allows for easy maneuverability, making it an ideal choice for overhead cuts and precise trimming.

Safety is a top priority, and the Poulan 530165555 incorporates several safety features to protect users. It includes a chain brake that engages automatically in the event of kickback, ensuring that the operator remains safe while working. Furthermore, the chainsaw features a low kickback bar and chain, contributing to a more predictable cutting action.

Another notable technology is the easy-start mechanism that simplifies ignition, allowing users to start the chainsaw with minimal effort. This feature is especially beneficial for those who may not have extensive chainsaw experience.

Maintenance is an essential aspect of any tool, and the Poulan 530165555 shines in this area as well. The chainsaw comes with a tool-less chain tensioning system, enabling users to adjust the chain quickly and easily without the need for additional tools. This ensures optimal performance and extends the life of the chain.

In conclusion, the Poulan 530165555 is a well-rounded chainsaw that combines power, durability, user-friendly features, and safety technologies. Its ability to handle various cutting tasks makes it an indispensable tool for homeowners and professionals alike. Whether you are pruning trees, cutting firewood, or tackling larger cutting jobs, the Poulan 530165555 stands out as a reliable and efficient solution.

Poulan 530165555 Starting a Warm Engine, Difficult Starting or starting a flooded engine