D Disconnect spark plug before performing maintenance except for carburetor adjust- ments.
D Use only recommended Poulan PRO re- placement parts; use of any other parts may void your warranty and cause damage to your unit.
DEmpty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and
letting it run until it stops.
D Do not use any accessory or attachment other than those recommended by manufac- turer for use with your unit.
DDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc.
DStore in a dry area out of reach of children. SPECIAL NOTICE: This unit is equipped with a temperature limiting muffler and spark arresting screen which meets the require- ments of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Ore- gon, and Washington require by law that many internal combustion engines be
equipped with a spark arresting screen. If you operate in a locale where such regulations ex- ist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. Refer to the MAINTENANCE section for information on maintenance of the muffler and spark arrest- ing screen.
SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or ab- normal swelling. Prolonged use in cold weather has been linked to blood vessel dam- age in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condi- tion of this tool.
ASSEMBLY
WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on the unit.
1.Locate and identify all components.
2.Connect the flexible tube to the outlet tube on the engine. Tighten the hose clamp.
3.Remove bottom screw from control han- dle. Install the control handle against the flared area on the base tube with the ON/ STOP switch facing the engine.
CARTON CONTENTS
1.Spark plug
2.Choke
3.Air filter
4.Starter handle
5.Fuel tank
6.Harness
7.Muffler
8.Control handle
9.Air nozzle
10.Blower outlet tube
11.Flexible tube
12.Throttle control
13.ON/STOP switch
14.Throttle adjuster
4.Connect the base tube to the flexible tube. Tighten the hose clamp.
5.Assemble the air nozzle to the middle tube and connect the assembly to the base tube by pushing the tubes together and turning them until they lock in place.
6.Remove throttle cable clamp from flexible tube. Place throttle cable in clamp and re- install on flexible tube.
