LIMBING
SLimb a tree only after it is cut down. S Leave the larger limbs underneath the
felled tree to support the tree as you work.
S Start at the base of the felled tree and work toward the top, cutting branches and limbs. Remove small limbs with one cut.
S Keep the tree between you and the chain.
S Remove larger branches with the cut- ting techniques described in BUCKING WITHOUT A SUPPORT.
S Always use an overcut to cut small and freely hanging limbs. Undercut- ting could cause limbs to fall and pinch the saw.
PRUNING
WARNING: Limit pruning to limbs shoulder height or below. Do not cut if branches are higher than your shoulder. Get a professional to do the job.
S Make your first cut 1/3 of the way through the bottom of the limb. This cut will make the limb sag so that it falls easily on the second cut.
S Next make a second cut all the way
through the limb.
SFinish the pruning operation by using an overcut so that the stump of the limb protrudes 1 to 2 inches from the trunk of the tree.
Second cut
First cut
1/3 of way
3rd cut 1 to 2 in. from trunk of tree
MAINTENANCE
CUSTOMER RESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
Fill in dates as you complete | Before | After | Every | Service |
regular service | Use | Use | 15 min. | Dates |
Check for damaged/worn parts | n |
|
|
|
Check for loose fasteners/parts | n |
|
|
|
Check chain tension | n |
|
|
|
|
|
|
|
|
Check chain sharpness | n |
|
|
|
Check guide bar | n |
|
|
|
Check bar and chain oil level | n |
| n |
|
Inspect and clean unit & labels |
| n |
|
|
Clean guide bar groove |
| n |
|
|
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to oper- ator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instruct- ed in this manual. Various adjustments will need to be made periodically to properly maintain your unit. Improper mainte- nance may cause damage to the unit and possible injury to the operator or by- standers.
11
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for replacement of damaged or worn parts. NOTE: It is normal for a small amount of oil to appear under the saw after motor stops. Do not confuse this with a leaking oil tank.
S Trigger Switch
