SKeep the handles dry, clean, and free from oil and grease.

S Keep oil cap, screws, and fasteners se- curely tightened.

SMaintain unit with care.

SKeep chain sharp and clean for better and safer performance.

SFollow instructions for lubricating and chang- ing accessories.

SCheck for damaged parts. Before further use of the unit, a part that is damaged should be carefully checked to determine that it will op- erate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. Any part that is damaged

should be properly repaired or replaced by an authorized service dealer unless otherwise indicated elsewhere in the instruction manual.

SUse only recommended attachments and re- placement parts to avoid creating a hazard

and/or voiding warranty.

SWhen not in use, the unit should be stored in a dry, high or locked-up place out of the reach of children.

S When storing unit, unplug and use a bar sheath.

TRANSPORTING AND STORAGE

S Stop the unit and disconnect the power source when not in use.

SCarry the unit with motor stopped.

SStore unit indoors in a high, dry place out of the reach of children. Store unit unplugged.

S Do not hang unit so that the trigger switch is depressed.

SAFETY NOTICE: Exposure to vibrations through prolonged use of hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti--vibration system does not guarantee the avoidance of these problems. Users who op- erate power tools on a continual and regular basis must monitor closely their physical con- dition and the condition of this tool.

RECOMMENDED ATTACHMENTS

This model is equipped with a coupler which enables optional attachments to be installed. The optional attachments are:

MODEL: Edger . . . . . . . . . . . . . . . . . . . . PP1000E Cultivator . . . . . . . . . . . . . . . . . PP2000T Blower . . . . . . . . . . . . . . . . . . . PP3000B

WARNING: Use of any other attach- ments besides those listed above and the at- tachment provided with this unit might present a risk of injury to the operator or bystanders. Only those attachments listed above and the attach- ment provided with this unit have been tested for use with this powerhead.

ADDITIONAL SAFETY RULES

FOR OPTIONAL ATTACHMENTS

WARNING: For each optional attach- ment used, read entire instruction manual be- fore use and follow all warnings and instruc- tions in manual and on attachment.

NOTE: Use the assist handle included with your unit (as shown below) when operating the following attachments.

Assist Handle

BLOWER SAFETY

WARNING: Never put hands or other objects into blower housing to avoid serious injury from rotating impeller.

WARNING: Inspect area before us- ing the unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.

S Inspect unit before each use for worn, loose, missing or damaged parts. Do not use until unit is in proper working order.

SDo not set unit on any surface except a clean, hard area. Debris such as gravel, sand, dust, grass, etc., could be picked up by the air in- take and thrown out through discharge open-

ing, damaging unit, property, or causing seri- ous injury to bystanders or operator.

SNever place objects inside the blower tubes or blower outlet. Always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automo- biles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to rico- chet which can hurt people or animals,

break glass, or cause other damage.

SCheck air intake opening and blower tubes frequently, always with unit stopped and power source disconnected. Keep vents and discharge tubes free of debris which

can accumulate and restrict proper air flow.

SNever place any object in air intake opening as this could restrict proper air flow and

cause damage to the unit.

SNever douse or squirt the unit with water or any other liquid. Clean unit and labels with a

damp sponge. Keep handles dry, clean, and free from oil and grease.

SNever use for spreading chemicals, fertiliz- ers, or other substances which may contain

toxic materials.

STo avoid spreading fire, do not use near leaf or brush fires, fireplaces, barbecue pits, ashtrays, etc.

CULTIVATOR SAFETY

DANGER: RISK OF CUT. KEEP HANDS AND FEET AWAY FROM TINES AND CUTTING AREA. Rotating tines can cause se- rious injury. Do not attempt to clear away cut material or hold material to be cut when the mo- tor is running. Make sure powerhead is stopped

6

Page 6
Image 6
Poulan 810 EP instruction manual Transporting and Storage, Recommended Attachments, For Optional Attachments, Blower Safety