SCut from your left to your right. Cutting on the right side of the shield will throw debris
away from the operator.
SUse only in daylight or good artificial light. S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
SStop the powerhead engine before carrying
unit.
SKeep muffler away from your body.
SAllow engine to cool and secure unit before
storing or transporting it in a vehicle.
SEmpty the fuel tank before storing or trans- porting the unit. Use up fuel left in the carbu- retor by starting the engine and letting it run until it stops.
SStore unit and fuel in an area where fuel va- pors cannot reach sparks or open flames
from water heaters, electric motors or switches, furnaces, etc.
SStore unit so the blade cannot accidentally
cause injury.
SStore unit indoors, out of reach of children.
If situations occur which are not covered in this manual, use care and good judgment. If you need assistance, call
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feel- ing in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
SAVE THESE INSTRUCTIONS
ASSEMBLY
CARTON CONTENTS
Check carton contents for the following:
SBrushcutter attachment S Handlebar
S Handlebar mounting bracket for 1″ shaft S Handlebar mounting bracket for 7/8″ shaft S Bracket cover (2)
S Shoulder strap
S Upper shoulder strap clamp
S Lower shoulder strap clamp (with spacer tabs) S Handlebar bracket screws (4)
S Shoulder strap clamp screws (2) S Attachment hanger
S Hex wrench
WARNING: If received assembled, re- peat all steps to ensure your unit is properly as- sembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
TOOLS REQUIRED
SHex wrench (provided)
INSTALLING BRUSHCUTTER AT- TACHMENT
CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
AttachmentLOOSEN
Knob
TIGHTEN
2.Remove the shaft cap from the brushcut- ter attachment (if present).
3.Position locking/release button of attach- ment into guide recess of coupler.
4.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
5.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper Release Attachment
Shaft Button
WARNING: Make sure the locking/re- lease button is locked in the primary hole and the knob is securely tightened before operat- ing the unit. Using the wrong hole could lead to serious injury or damage to the unit.
4
