with the engine/motor running. Stop engine and disconnect spark plug before unclogging snow or debris from discharge chute or when adjusting vanes.
WARNING: Never lean over dis- charge chute. Rocks or debris could be thrown into the eyes and face and cause seri- ous injury or blindness.
WARNING: Inspect the area where the unit is to be used. Remove objects that could be thrown or damage the unit. Some objects may be hidden by fallen snow
SDirect material discharge away from glass
enclosures, automobiles, etc.
SDo not run engine at high speed while not removing snow.
SBe attentive when using the snowthrower, and stay alert for holes in the terrain and other hidden hazards.
SMake sure the rotor will spin freely before at- taching the snowthrower to the powerhead.
SIf the rotor will not rotate freely due to frozen ice, thaw the unit before thoroughly before
attempting to operate under power.
SKeep the rotor clear of debris.
SDo not throw snow near other people. The
snow thrower could propel small objects at high speed causing injury.
SAfter striking a foreign object, stop the en- gine, disconnect spark plug and inspect the snowthrower for damage and repair if nec-
essary before restarting unit.
SNever operate the snowthrower near glass
enclosures, automobiles and trucks.
SNever attempt to use the snowthrower on a roof.
SNever operate the snowthrower near win- dow wells, dropoffs, etc.
SNever discharge snow onto public roads or near moving traffic.
SClear snow from slopes by going up and down; never across. Use caution when changing directions. Never clear snow
from steep slopes.
SLet snowthrower run for a few minutes after clearing snow so moving parts do not
freeze.
SLook behind and use care when backing up. Exercise caution to avoid slipping or fal- ling, especially when operating in reverse.
SKnow how to stop quickly.
ASSEMBLY
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
INSTALLING TRIMMER ATTACH- MENT
CAUTION: When installing trimmer attach-
ment, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
Shipping
protectorLOOSEN
Knob
TIGHTEN
2.Remove shipping protector from coupler.
3.Remove the shaft cap from the trimmer attachment (if present).
4.Position locking/release button of attach- ment into guide recess of coupler.
5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
6.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper Release Attachment
Shaft Button
WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole could lead to seri- ous injury or damage to the unit.
8
