Poulan PB22H46YTX Fig See REMOVAL BLADE, Maintenance, Tractor, 13 .FIG, warranty your void and

15

.tractor from battery remove and cable tery
-bat RED then first cable battery BLACK Disconnect			•
		.guard terminal Remove	•
		.power “leak” to battery the
cause can terminals and battery the on dirt and Corrosion
	TERMINALS AND BATTERY CLEAN TO
		.necessary
not is electrolyte of level checking or Adding .covers or
caps remove or open to attempt not Do .free maintenance
is tractor your on battery equipment original The NOTE:
	.hour 1 for amperes 10-6 at Recharge		•
		.open holes vent small Keep	•
		.tight bolts battery Keep	•
		.clean terminals and battery Keep	•
.life its extend will charger automotive an with
battery the of charging periodic However, .use normal for
cientfisuf is which system charging battery a has tractor Your
		BATTERY
		13 .FIG
STAR
	544	02
		(SPECIAL)
		BOLT BLADE
		HOLE
		CENTER
ASSEMBLY		BLADE
MANDREL
.treated heat is bolt blade Special :IMPORTANT
		.torque)
.Lbs .Ft 55-(45 securely bolt blade tighten and Install			•
.assembly mandrel on star with align must blade
in hole center bly,semas proper ensure To IMPORTANT:
		.ground the
facing SIDE" "GRASS stamped with blade new Install			•
.wiseclocktercoun turning by bolt blade Remove			•
		.cloth heavy with
blade wrap and/or gloves with hands your Protect NOTE:
		.blades
to access allow to position highest to mower Raise			•
	13) .Fig (See REMOVAL BLADE
		.warranty your void and
tractor your damage could hazardous,
is tractor your of manufacturer the by
approved not blade a Using .tractor
your of manufacturer the by approved
bladereplacementaonlyUse CAUTION:
		.blades damaged or bent worn,
placeRe .sharp be must blades mower results best For
		CARE BLADE

	.engine the off shut NOT should
reverse into shift to operator the by attempt any gaged,
-en clutch menttachat the and position "ON" ROS the
in switch ignition the with running is engine the When		•
	.engine the off shut should reverse
into shift to operator the by attempt any engaged,
clutch menttachat the and position "ON" engine the
in switch ignition the with running is engine the When		•
SYSTEM (ROS) OPERATION REVERSE CHECK
8282	0

Operating) (Normal	Position "ON" ROS
Position "ON" Engine
	.seat the in is operator the
unless operate never should clutch attachment The		•
.engine the off shut should seat
the leave to operator the by attempt any engaged, is
clutch menttachat the and running is engine the When		•
.engine the off shut should
brake parking the setting first without seat the leave to
toraerop the by attempt any running, is engine the When		•
SYSTEM PRESENCE OPERATOR CHECK
.position gagedendis the in
is trolcon clutch attachment the and pressed,de fully
is pedal brake the unless start not should engine The		•
.immediately problem the repair described,
as function not does tractor your If .properly ingwork are
temssys operation reverse and presence operator sure Be
	(ROS) SYSTEM ERATION
-OP REVERSE AND TEMSYS PRESENCE OPERATOR
	.corrosion
and rot dry tire ventspre also sealant Tire .dealer parts
local your from purchased be may sealant tire leaks, slow
to due tires flat ventpre and punctures tire seal To NOTE:
.damage tire cause may that hazards other
and objects sharp ruts, deep stones, stumps, Avoid		•
.rubber harm can which cals
-chemi control insect or oil, gasoline, of free tires Keep		•
	.tires)
on PSI (See tires all in pressure air proper Maintain		•
	TIRES
	.manual)
this of section mentsjustAd and viceSer the in BRAKE”
CHECK “TO (See .serviced be must brake then surface,
paved or concrete dry level, a on gear esthigh in speed
highest at stop to feet (5) five than more requires tractor If
	OPERATION BRAKE
	.nancete
-main any ingformper when rules safety observe Always
	TRACTOR

MAINTENANCE