operate in a locale where such regulations ex- ist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arrest- ing screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your Au- thorized Service Dealer.
SLift handlebar to upright position. Handlebar
CARTON CONTENTS
Check carton contents for the following:
Sbrushcutter
Sblade shield screws (4) S cupped washer
S large nut for installing blade S long hex wrench
S metal shield S plastic shield
S shoulder strap with warning S weed blade
S trimmer head (assembled on unit) S handlebar (assembled on unit)
S container of oil
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
It is normal for the fuel filter to rattle in the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
ASSEMBLY
WARNING: Always stop unit and dis- connect spark plug before performing any as- sembly procedures.
WARNING: Make sure your unit is properly assembled and all fasteners are se- cure.
TOOLS REQUIRED
SHex wrench (provided) S Adjustable wrench
ADJUST AND SECURE THE HAN- DLEBAR
DANGER: During blade usage, the barrier portion of the handlebar must be ad- justed and remain installed as shown to pro- vide a barrier between operator and the spin- ning blade. The handlebar clamp must be positioned between the arrows on the handle- bar decal.
4
S Rotate handlebar/clamp counterclockwise toward engine until clamp falls into groove of base.
Handlebar
Handlebar
Clamp
Clamp 
Knob
Clamp
Base
SPlace the handlebar in a comfortable oper- ating position.
SRetighten handlebar by turning clamp knob clockwise until handlebar is secure and sta- tionary in clamp base (clamp knob can not be overtightened).
ASSEMBLY OF SHOULDER STRAP
WARNING: Proper shoulder strap and handlebar adjustments before starting the engine are required.
STry on shoulder strap and adjust for fit and balance before starting the engine or begin- ning a cutting operation.
SInsert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.
NOTE: A
S Adjust the strap, allowing the hook to be about 6 inches below the waist.
SFasten the strap hook to the clamp located between the trigger handle and the handle- bar clamp base and lift the tool to the oper- ating position.
CONFIGURING YOUR UNIT
You can configure your unit using a cutting head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch in diameter. To assemble your unit, go to the section for the desired configuration and follow the instructions.
