Poulan 964 04 06-07, CG46A, 151673 owner manual REAR MOUNTING BRACKET and

1	REAR MOUNTING BRACKET and
	SUPPORT PLATE (See Figs. 1A & 1B)

Use Hardware - - GROUP "A"

1.Install support plate to inside of drawbar as shown, using two (2) 7/16-14 x 3/4 hex bolts and the two threaded upper holes in the plate. Do not tighten at this time.

NOTE: Be sure to align the four (4) lower threaded holes of the support plate with the holes in the drawbar.

2.Assemble the mounting bracket as shown to the outside of the drawbar using four (4) 7/16-14 x 3/4 hex bolts and the four (4) lower threaded holes of the support plate. Tighten all hardware securely.

HEX BOLTS

THREADED UPPER HOLES

SUPPORT

PLATE

DRAWBAR

02357

Fig. 1A

MOUNTING

BRACKET

SUPPORT PLATE

HEX

BOLTS

	THREADED
DRAWBAR	LOWER HOLES

Fig. 1B

2	COVER SEAL (See Fig. 2)
	No hardware required

1.Align mark on seal with mark at cover opening.

2.Work seal into opening so cover sits between flanges of seal.

02086

ALIGNMENT

MARKS

	COVER SEAL
	Fig. 2
3	SUPPORT POST (See Fig. 3)
	Use Hardware - - GROUP "B"

1.Rotate cover assembly onto its side as shown.

2.Secure support tubes to cover assembly using short hex bolts, long hex bolts, and locknuts as shown. Tighten all hardware securely.

COVER

ASSEMBLY

SHORT

HEX BOLTS

LONG

HEX BOLTS

LOCKNUTS

56 023

LOCKNUTS

S U P P O R T

POSTS

Fig. 3

7