Retainer
Spring
Pin
Shoulder
Bolt Adjusting
Bar 
Gauge
Wheel
3/8 Washer | ||
Locknut | ||
|
INSTALL MOWER AND DRIVE BELT
Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake.
1.Cut and remove ties securing anti- sway bar and belts. Swing
2.Slide mower under tractor with deflec-
tor shield to right side of tractor. IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.
3.If equipped, turn height adjustment knob counterclockwise until it stops.
4.Lower mower linkage with attachment lift control.
5.Be sure belt tension rod is in disen- gaged position.
6.Install belt into electric clutch pulley groove.
7.Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown.
8.Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.
9.Position front plate assembly between front mower brackets. Raise deck and plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between
the plate assembly and mower brack- ets.
NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower
IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.
10. Engage belt tension rod by pushing rod into locking bracket.
CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and en- gage slowly.
11.Connect
Belt Tension Rod Disengaged Position
Chassis
Bracket
Gauge
Wheel
Double Loop
Retainer
Spring
USE PLIERS FOR
RETAINER SPRINGS
Loop Up
Lock Bracket | Electric Clutch |
|
| |
|
|
| ||
| Pulley | Front |
|
|
|
|
|
| |
|
| Suspension | Front Plate |
|
| Front | Brackets | Assembly |
|
|
|
| ||
|
|
|
| |
| Mower |
| Double |
|
| Bracket |
|
| |
|
| Loop Retainer | ||
|
|
| ||
|
|
| Springs |
|
|
|
|
| Single |
|
|
| Flanged | Loop |
|
|
| Retainer | |
|
|
| Pin | |
|
|
| Springs | |
|
|
|
| |
Bar
Suspension Arms |
|
Double Loop |
|
Retainer Spring |
|
(Outward pointing | Deflector Shield |
deck pins) | 10 |
|
